Sensitivity to dynamic strain aging in C—Mn steels
نویسندگان
چکیده
منابع مشابه
an investication into the strain aging of low carbon steels
in this paper, the effect of prestrain on strain aging of low carbon steels, in the temperatures of 100°c and 200°c and the aging time of 50 minutes, and also the effect of aging temperature on strain aging in a constant aging time and prestrain, are investigated. the results of experiments show that with increasing the amount of prestrain, the increase in yield stress and ultimate tensile stre...
متن کاملPREDICTION OF CRITICAL STRESS AND STRAIN FOR THE ONSET OF DYNAMIC RECRYSTALLIZATION IN PLAIN CARBON STEELS
The aim of the present study is the prediction of critical conditions (including critical strain and flow stress) for the initiation of dynamic recrystallization during thermo-mechanical processing of plain carbon steels. For this propose, torsion tests were conducted at different temperature (1050, 1100 and 1150˚C) and strain rates (0.002, 0.02 and 0.2/s). All flow curves showed a peak st...
متن کاملPlastic strain due to twinning in austenitic TWIP steels
Twinning induced plasticity steels are austenitic alloys in which mechanical twinning is a prominent deformation mode, and which exhibit exceptional combinations of ductility, work hardening and ultimate strength. The authors develop in the present paper a crystallographic theory to enable the quantitative investigation of the role of mechanical twinning in enhancing the properties of these all...
متن کاملSecondary Hardening Behavior in Super Duplex Stainless Steels during LCF in Dynamic Strain Ageing Regime
Cyclic deformation behaviors in five modified duplex and 350°C. The influence of temperature and ni phenomenon, in the stress response curve was focuse dynamic strain ageing by increasing the first hardeni Furthermore, an increase in nitrogen concentration in ageing temperature range. The occurrence of strai structures. The formation of irreversible dislocation s hardening in the stress respons...
متن کاملSTRAIN INDUCED AUSTENITE-TO-FERRITE TRANSFORMATION BEHAVIOR OF PLAIN CARBON STEELS THROUGH SINGLE PASS ROLLING
In principal, a proper combination of strength and ductility is achieved through micro component refinement in steels. This is particularly empowered with ferrite refinement down to micron sizes in ferrite pearlite engineering steels. The latter is achieved through various well-defined methods in which strain induced transformation (SIT) has shown spectacular capabilities. In the present study,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Alloys and Compounds
سال: 1994
ISSN: 0925-8388
DOI: 10.1016/0925-8388(94)90465-0