Sensitivity analysis of Polymer Laboratories' dynamic mechanical thermal analyzer
نویسندگان
چکیده
منابع مشابه
Dynamic mechanical thermal analysis of denture soft lining materials.
The purpose of this study was to characterize the deformation properties of a range of long-term denture soft lining materials using dynamic mechanical thermal analysis. Specimens were subjected to sinusoidal shear deformation at a frequency of 1 Hz and a strain of 64 microns peak to peak over a temperature range of 30-70 degrees C. The technique simulated the type and rate of deformation soft ...
متن کاملSensitivity Analysis of Different Parameters Affecting Thermal Contact Conductance
In internal combustion engines, exhaust valve and its seat gain considerable temperature as the hot gases exit through them. So, the rate of heat transfer should be under control. In this study, the contact heat transfer coefficient has been estimated. An experimental study on an Air-Cooled internal combustion engine cylinder head has been considered. Using the measured temperatures of sensors ...
متن کاملDynamic mechanical response of polymer networks
The dynamic-mechanical response of flexible polymer networks is studied in the framework of tube model, in the limit of small affine deformations, using the approach based on Rayleighian dissipation function. The dynamic complex modulus G∗(ω) is calculated from the analysis of a network strand relaxation to the new equilibrium conformation around the distorted primitive path. Chain equilibratio...
متن کاملSensitivity Analysis of Water Flooding Optimization by Dynamic Optimization
This study concerns the scope to improve water flooding in heterogeneous reservoirs. We used an existing, in-house developed, optimization program consisting of a reservoir simulator in combination with an adjoint-based optimal control algorithm. In particular we aimed to examine the scope for optimization in a two-dimensional horizontal reservoir containing a single high permeable streak, ...
متن کاملThermal And Thermo-Mechanical Modelling of Polymer Overmoulded Electronics
This paper reports on the results from a research project investigating a novel technology for the manufacture of recyclable polymeric modules with embedded electronic controls and power distribution. The aim of this project is to develop a technology that fully encapsulates electronics for use in the demanding automotive environment. A two shot moulding technology will protect delicate electro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Journal of the Acoustical Society of America
سال: 1988
ISSN: 0001-4966
DOI: 10.1121/1.2026068