SEM Investigations of TiB2 and TiBN Coatings Produced by DC Magnetron Sputtering
نویسندگان
چکیده
منابع مشابه
A comparative study of thin coatings of Au/Pd, Pt and Cr produced by magnetron sputtering for FE-SEM.
Visualization of structural details of specimens in field emission scanning electron microscopy (FE-SEM) requires optimal conductivity. This paper reports on the differences in conductive layers of Au/Pd, Pt and Cr, with a thickness of 1.5–3.0 nm, deposited by planar magnetron sputtering devices. The coating units were used under standard conditions for source–substrate distance, current, HT an...
متن کاملCrNx Films Prepared by DC Magnetron Sputtering and High-Power Pulsed Magnetron Sputtering: A Comparative Study
CrNx (0 ≤ x ≤ 0.91) films synthesized using highpower pulsed magnetron sputtering, also known as high-power impulse magnetron sputtering (HiPIMS), have been compared with those made by conventional direct-current (dc) magnetron sputtering (DCMS) operated at the same average power. The HiPIMS deposition rate relative to the DCMS rate was found to decrease linearly with increasing emission streng...
متن کاملBioactivity response of Ta1-xOx coatings deposited by reactive DC magnetron sputtering.
The use of dental implants is sometimes accompanied by failure due to periimplantitis disease and subsequently poor esthetics when soft-hard tissue margin recedes. As a consequence, further research is needed for developing new bioactive surfaces able to enhance the osseous growth. Tantalum (Ta) is a promising material for dental implants since, comparing with titanium (Ti), it is bioactive and...
متن کاملOsteoblast proliferation on hydroxyapatite thin coatings produced by right angle magnetron sputtering.
Right angle magnetron sputtering (RAMS) was used to produce hydroxyapatite (HA) film coatings on pure titanium substrates and oriented silicon wafer (Si(0 0 1)) substrates with flat surfaces as well as engineered surfaces having different forms. Analyses using synchrotron XRD, AFM, XPS, FTIR and SEM with EDS showed that as-sputtered thin coatings consist of highly crystalline hydroxyapatite. Th...
متن کاملDEPOSITION OF THIN TiO2 FILMS BY DC MAGNETRON SPUTTERING METHOD
Sputter deposition process is another old technique being used in modern semiconductor industries. Sputtering is a process that can deposit TiO2 material on wafer/glass substrates. In this process target is connected to negative high voltage. Further argon gas is introduced into the chamber and is ionized to a positive charge. The positively charged argon atoms are attracted and strike the nega...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2009
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927609092484