Seismic Retrofit Design Procedure Using a Friction Damper
نویسندگان
چکیده
منابع مشابه
External seismic pre-isolation retrofit design
This technical note outlines the design of an external seismic pre-isolation system proposed for use in LIGO Livingston. The goal is to reduce the effects of the site’s excess ground noise in the 1 3 Hz frequency band, allowing detector noise performance equivalent to that of the 4 km LIGO Hanford detector. The center histogram in Figure 8 shows the most troubling aspect of the excess noise qui...
متن کاملUsing Composites in Seismic Retrofit Applications
This report was prepared to provide a comprehensive review of the state-of-the-art for using composite materials for seismic retrofit applications. The emphasis is on seismic retrofit of reinforced concrete columns. The report is presented in eleven chapters. Chapters 1–3 provide a basic introduction to composite materials, including discussions on the types of matrix and reinforcement material...
متن کاملExperimental Study on Seismic Response Mitigation of Complex Structure using Passive Friction Damper
The application of control devices in coupled building system has been recently recognized as an effective alternative for seismic protection. In consideration of passive control approach, most of previous studies focused on application of fluid dampers, and the buildings in the coupled systems were in similar structural configuration. By recognizing the potential merits, such as simple in desi...
متن کاملReliability-based Design of Seismic Retrofit for Bridges
This research focused on developing reliability-based seismic retrofit assessment procedures for highway bridge columns. Fragility curves were developed to assess the relative performance of various retrofit methods considering several limit states. Analytical fragility curves are developed from scaled earthquake records and structural response models. A simplified, single-degree-of-freedom (SD...
متن کاملDesign and Evaluation of Hydro-Pneumatic Friction Damper Suspension System
Perceived comfort level and ride stability are the two most important factors in the evaluation of suspension system in a mobile vehicle. It is extremely difficult to simultaneously maintain a high standard of vehicle ride, handling and body control in the vehicle by using conventional passive suspension system. However, the use of active suspensions would result in better comforts than the pas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Earthquake Engineering Society of Korea
سال: 2011
ISSN: 1226-525X
DOI: 10.5000/eesk.2011.15.6.045