Seismic Performance Evaluation of 500 kV EBA
نویسندگان
چکیده
منابع مشابه
INITIAL PERFORMANCE OF A 500 kV, CHOPPER PREBUNCHER INJECTION SYSTEM FOR A 17 GHz LINAC*
The design features of a 17 GHz chopper prebuncher injection system are described, and initial test results operating with a 500 kV low emittance electron gun and single section 17 GHz linac are presented. The 17 GHz traveling wave relativistic klystron that provides RF power to the linac structure, and the 500 kV electron gun that forms the low emittance (βγ ε = 3π mm-mradian) source for the i...
متن کاملProbabilistic Evaluation of Seismic Performance of RC Bridges in Iran
Many existing bridges were designed without adequate consideration of seismic risk. The full or partial collapse of even one major bridge in a city or community would have destroying results. There has been focuses on developing fragility-based seismic vulnerability of existing usual bridges in Iran or support decision making on seismic upgrade. This article focuses on developing performance b...
متن کاملA NEW APPROACH FOR EVALUATION OF SEISMIC SLOPE PERFORMANCE
The evaluation of seismic slope performance during earthquakes is important, because the failure of slope (such as an earth dam, natural slope, or constructed earth embankment) can result in significant financial losses and human. It is important, therefore, to be able to forecast such displacements induced by earthquake. However, the traditional forecasting methods, such as empirical formulae,...
متن کاملExperimental Study of the Seismic Performance of L-Shaped Columns with 500 MPa Steel Bars
Based on tests on six L-shaped RC columns with 500 MPa steel bars, the effect of axial compression ratios and stirrup spacing on failure mode, bearing capacity, displacement, and curvature ductility of the specimens is investigated. Test results show that specimens with lower axial load and large stirrup characteristic value (larger than about 0.35) are better at ductility and seismic performan...
متن کاملSEISMIC PERFORMANCE OF CROSS-SHAPED COLUMNS WITH 500 MPa GRADE REINFORCING STEEL BARS
Original scientific paper Based on the experimental research on three cross-shaped columns with 500 MPa grade reinforcing steel bars, the contrastive analysis is made on failure mode, bearing capacity and displacement ductility of each column specimens with different stirrup spacing under the identical axial compression ratio. The research shows that the longitudinal bars yield before spalling ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Korean Society for Noise and Vibration Engineering
سال: 2015
ISSN: 1598-2785
DOI: 10.5050/ksnve.2015.25.7.496