SEISMIC BEHAVIOR AND DESIGN OF ASSEMBLED SLIT SHEAR WALLS USING LOW YIELD POINT STEEL
نویسندگان
چکیده
منابع مشابه
Seismic Behavior of Intermediate Beams in Steel Plate Shear Walls
This paper presents some preliminary results of an ongoing research whose objective is to investigate the seismic behavior of intermediate beams (i.e., the beams other than those at the roof and foundation levels) in multi-story steel plate shear walls (SPSWs). Of primary interest is the determination of the strength level needed to avoid the formation of in-span plastic hinges, a relevant prac...
متن کاملnon-linear study of various slit shear walls in steel structures
seismic retrofit strategies have been developed in the past few decades following the introduction of new seismic provisions and the availability of advanced materials and methods. it can be observed that new approaches to deal with more lateral forces are more innovative and more energy absorbent. in line with this, there is a growing trend toward the use of steel shear walls as a system with ...
15 صفحه اولThe Lightweight Design of a Seismic Low-Yield-Strength Steel Shear Panel Damper
The lightweight design and miniaturization of metallic dampers have broad application prospects in seismic engineering. In this study, the superplastic property and the maximum energy dissipation capacity per unit mass of low-yield-strength steel (LYS) are investigated via comparison with those of several common metallic damping materials by tests. Additionally, the boundary constraints of an L...
متن کاملductility-based seismic design of steel plate shear walls: practical application using standard sections
over the past decade of extensive research works, the thin un-stiffened steel plate shear wall(spsw) has now emerged as a promising lateral load resisting system. considering thedemand of performance-based seismic design (pbsd) philosophy in current and futureseismic design codes, a ductility-based design was recently proposed for spsw systems withpin-connected boundary beams. however, the effe...
متن کاملBehavior of Steel-Sheathed Shear Walls Subjected to Seismic and Fire Loads.
A series of tests was conducted on six 2.7 m × 3.7 m shear wall specimens consisting of cold-formed steel framing sheathed on one side with sheet steel adhered to gypsum board and on the opposite side with plain gypsum board. The specimens were subjected to various sequences of simulated seismic shear deformation and fire exposure to study the influence of multi-hazard interactions on the later...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2016
ISSN: 1340-4202,1881-8153
DOI: 10.3130/aijs.81.335