Secondary Flow in a Curved Duct Having Inlet Distortion.
نویسندگان
چکیده
منابع مشابه
Fluid flow and heat transfer characteristics in a curved rectangular duct using Al2O3-water nanofluid
In the present research, the laminar forced convective heat transfer and fluid flow characteristics for Al2O3-water nanofluid flowing in different bend (i.e., 180o and 90o) pipes have been investigated numerically in a three-dimensional computational domain using the finite volume technique. The effects of different pertinent parameters, such as the Reynolds number of the duct, volume fraction ...
متن کاملFlow Investigation in a Constant Area Curved Duct
The present study dealt with the wall static pressure of a rectangular curved duct with angle of turn 90° at all four faces with various locations. The normalized wall static pressure distributions at the top, bottom, inside and outside surfaces of the C-duct are drawn in the form of contours at three different air velocities, Uav = 20m/s, 40m/s and 60m/s respectively. These iso-bar contours in...
متن کاملLarge-scale secondary structures in duct flow
The spatial growth of small perturbations developing on a fully developed base flow in a duct with two inhomogeneous cross-flow directions is examined. For a laminar mean flow it is shown that optimally configured vortices at an upstream cross-section induce large transient amplification of a disturbance energy norm downstream. Such a linear growth is a likely initial stage of transition in duc...
متن کاملA Robust Design Methodology for Optimal Microscale Secondary Flow Control in Compact Inlet Diffusers
It is the purpose of this study to develop an economical Robust design methodology for micro-scale secondary flow control in compact inlet diffusers. To illustrate the potential of economical Robust Design methodology, two different mission strategies were considered for the subject inlet, namely (1) Maximum Performance, and (2) Maximum HCF Life Expectancy. The Maximum Performance mission maxim...
متن کاملHeat Transfer from a Tube Bank in Cross Flow in a Duct
An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies 
in the range 0.055<D/W<0.22. The experimen...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1997
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.63.1554