Secondary Explosions in Relief Duct During Aluminum Dust Explosion Venting

Dust Explosion Venting in Silos: a Comparison of Standards NFPA 68 and EN 14491

Venting devices are commonly used to try to reduce the damage caused by any dust explosion that may occur in silo systems. In North America and Europe the sizing of these vent areas is governed by standards NFPA 68 and EN 14491 respectively, both of which have recently come into force. The aim of the present work was to compare these standards in terms of the cost of protecting against dust exp...

Explosion dust particle size measurements.

In situ measurements of the sizes and concentrations of dust particles generated by the detonation of high explosives in clay soil near Leesville, La., sandy clay soil near Huntsville, Ala., and sandy soils near Orogrande, N.M. are reported. Measurements were generally made within 1 m of the surface (in one case 10 m) at distances ranging from 10 to approximately 50 m from the detonation point ...

Frequency and Causes of Grain Dust Explosions

Grain dust explosions at elevators are in reality a series of explosions. The first explosion referred to as the "primary explosion" is usually small with pressures less than 2 pounds per square inch, (psi). It propagates a pressure wave and fire front. The pressure wave moves away from the location of the primary explosion at a speed of about 1000 feet per second (fps) while the fire front fol...

Overall characterization of cork dust explosion.

Explosibility and ignitability studies of air/cork dust mixtures were conducted in a near-spherical 22.7 L explosibility test chamber using pyrotechnic ignitors and in a furnace of 1.23 L. The suspension dust burned as air-dispersed dust clouds and the uniformity of the dispersion inside the chamber was evaluated through optical dust probes. The range of tested particle sizes went from a mass m...

Dust Explosion Propagation: Myths and Realities