Scribing of a-Si thin-film solar cells with picosecond laser
نویسندگان
چکیده
منابع مشابه
CIGS thin-film solar module processing: case of high-speed laser scribing
In this paper, we investigate the laser processing of the CIGS thin-film solar cells in the case of the high-speed regime. The modern ultra-short pulsed laser was used exhibiting the pulse repetition rate of 1 MHz. Two main P3 scribing approaches were investigated - ablation of the full layer stack to expose the molybdenum back-contact, and removal of the front-contact only. The scribe quality ...
متن کاملLaser Scribing: a Key Enabling Technology for Manufacturing of Low Cost Thin Film Photovoltaic Cells
Solar cells are becoming a highly promising alternative energy source for various markets. In the last five years or so a tremendous amount of research effort has been put into increasing the efficiency of solar cell technology and reducing its manufacturing cost. It is believed that success in both of these areas will further propel its use in various markets. The two major structures commerci...
متن کاملPlasmonic light trapping in thin-film Si solar cells
Plasmonic nanostructures have been recently investigated as a possible way to improve absorption of light in solar cells. The strong interaction of small metal nanostructures with light allows control over the propagation of light at the nanoscale and thus the design of ultrathin solar cells in which light is trapped in the active layer and efficiently absorbed. In this paper we review some of ...
متن کاملFlexible carbon nanotube/mono-crystalline Si thin-film solar cells
Flexible heterojunction solar cells were fabricated from carbon nanotubes (CNTs) and mono-crystalline Si thin films at room temperature. The Si thin films with thickness less than 50 μm are prepared by chemically etching Si wafer in a KOH solution. The initial efficiency of the thin-film solar cell varies from approximately 3% to 5%. After doping with a few drops of 1 M HNO3, the efficiency inc...
متن کاملThin-film Silicon Solar Cells
The simplest semiconductor junction that is used in solar cells for separating photogenerated charge carriers is the p-n junction, an interface between the p-type region and ntype region of one semiconductor. Therefore, the basic semiconductor property of a material, the possibility to vary its conductivity by doping, has to be demonstrated first before the material can be considered as a suita...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The European Physical Journal Applied Physics
سال: 2010
ISSN: 1286-0042,1286-0050
DOI: 10.1051/epjap/2010110