Scanning Tunneling Microscope Observation of Surface Morphology of Silicon Steel Sheets

Fabrication of silicon nanostructures with a scanning tunneling microscope

A technique is presented for fabricating Si nanostructures with a scanning tunneling microscope operated in air. The process involves the direct chemical modification of a H-passivated Si( 100) surface and a subsequent liquid etch. The chemically modified portions of the surface can withstand a deep ( > 100 nm) liquid etch of the unmodified regions with no etch degradation of the modified surfa...

Simulating Scanning Tunneling Microscope

Reproducible Fabrication of Scanning Tunneling Microscope Tips

Reproducible fabrication of Scanning Tunneling Microscope tips is carried out following an electrochemical procedure widely reported. Tips are made from 0.5 diameter tungsten wire. Controlling fabrication parameters (immersion in the electrochemical solution, current-voltage ranges, duration of the process, among others) we achieve aspect ratios of 0.68 and tip radii of 330 nm in the best case....

Theory of the scanning tunneling microscope.

We present a theory for tunneling between a real surface and a model probe tip, applicable to the recently developed "scanning tunneling microscope." The tunneling current is found to be proportional to the local density of states of the surface, at the position of the tip. The effective lateral resolution is related to the tip radius R and the vacuum gap distance d approximately as [(2 A)(R +d...

effect of laser treatment on surface morphology of indirect composite resin: scanning electron microscope (sem) evaluation

introduction: the aim of this study was to evaluate and compare the scanning electron microscope (sem) of indirect composite conditioned by erbium-doped yttrium aluminum garnet (er:yag) laser, neodymium-doped yttrium aluminium garnet (nd:yag) laserand carbon dioxide (co2) laser. methods: 18 indirect composite blocks (gc gradia da2, japan) with 15 × 10 × 10 mm dimensions were made. the bonding s...