Scanning Based Induction Heating for AISI 4340 Steel Spline Shafts-3D Simulation and Experimental Validation
نویسندگان
چکیده
منابع مشابه
Scanning Based Induction Heating for AISI 4340 Steel Spline Shafts-3D Simulation and Experimental Validation
This paper presents an investigation of non-stationary induction heating process applied to AISI 4340 steel spline shafts based on 3D simulation and experimental validation. The study is based on the knowledge, concerning the form of correlations between various induction heating parameters and the final hardness profile, developed in the case of stationary induction heating. The proposed appro...
متن کاملexperimental investigation and 3d simulation of reaming process on aisi d2 hardened tool steel
0
متن کاملInvestigation and Modeling of Electrical Discharge Machining Process Parameters for AISI 4340 steel
N. Annamalai, V. Sivaramakrishnan, B. Suresh kumar, N.Baskar Department of Mechanical Engineering, Mookambigai College of Engineering, Pudukkottai, Tamilnadu, India – 622502 [email protected] * Department of Mechanical Engineering, Roever Engineering College, Perambalur, Tamilnadu, India – 621212 [email protected] #3,*4 Department of Mechanical Engineering, M. A. M. College of Engineeri...
متن کاملExperimental Investigation of surface roughness in dry turning of AISI 4340 alloy steel using PVD- and CVD- coated carbide inserts
The performance of coated inserts was described using Response Surface Methodology (RSM) when turning AISI 4340 alloy steel using single layer PVD and triple layer CVD coated inserts. Cutting tests were performed under dry cutting conditions so as to reduce the effects of cooling agents on the environment. Surface roughness (Ra) was the main response variable investigated. The experimental plan...
متن کاملOptimization of Surface Roughness in Hard Turning of AISI 4340 Steel using Coated Carbide Inserts
The use of multilayer coated carbide tool in hard turning has several advantages over grinding process such as; reduction of processing costs, increased productivity, short cycle time, compatible surface roughness and less enviornment problems without the use of cutting fluid. In the present study, an attempt has been made to evaluate the performance of multilayer coated carbide inserts during ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Materials Physics and Chemistry
سال: 2017
ISSN: 2162-531X,2162-5328
DOI: 10.4236/ampc.2017.76021