Scan Cell Grouping Algorithm for Low Power Design
نویسندگان
چکیده
منابع مشابه
Low-Power Adder Design for Nano-Scale CMOS
A fast low-power 1-bit full adder circuit suitable for nano-scale CMOS implementation is presented. Out of the three modules in a common full-adder circuit, we have replaced one with a new design, and optimized another one, all with the goal to reduce the static power consumption. The design has been simulated and evaluated using the 65 nm PTM models.
متن کاملdesign of an analog ram (aram)chip with 10-bit resolution and low-power for signal processing in 0/5m cmos process
برای پردازش سیگنال آنالوگ در شبکه های عصبی ، معمولا نیاز به یک واحد حافظه آنالوگ احساس میشود که بدون احتیاج به a/d وd/a بتواند بطور قابل انعطاف و مطمئن اطلاعات آنالوگ را در خود ذخیره کند. این واحد حافظه باید دارای دقت کافی ، سرعت بالا ، توان تلفاتی کم و سایز کوچک باشد و همچنین اطلاعات را برای زمان کافی در خود نگهدارد. برای پیاده سازی سیستمی که همه این قابلیتها را در خود داشته باشد، کوشش...
15 صفحه اولDesign of Ultra Low Power SRAM Cell
In order to achieve a longer battery life suppression of energy consumption is vital. A demand for design methods for less energy consumption is increasing. The subthreshold scaling can reduce energy per cycle significantly by the scaling of supply voltage (VDD) below threshold voltage (Vth). Threshold voltage of CMOS technology represents the value of the gate-source voltage when the current i...
متن کاملDouble-Tree Scan: A Novel Low-Power Scan-Path Architecture
states at circuit nodes may erroneously change. Further, BIST schemes with random test patterns may need an excessive amount of energy because of longer test length. Abstract I n a scan-based system with a large number of flip-flops, a major component of power is consumed during scanshift and clocking operation in test mode. In this paper, a novel scan-path architecture called double-tree scan ...
متن کاملScan Based Circuits with Low Power Consumption
In this paper we present a low power scan design method. Nowadays the Boundary Scan (BS) diagnostic access to the circuit input and output cells combined with a scan chain of concatenated internal flip-flops (FF) has become to be a standard. An alternative parallel diagnostic access method called Random Access Scan (RAS) is not used in nowadays ICs because of more difficult routability. In spit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrical Engineering and Technology
سال: 2008
ISSN: 1975-0102
DOI: 10.5370/jeet.2008.3.1.130