ScAlN Thick-Film Ultrasonic Transducer in 40–80 MHz
نویسندگان
چکیده
منابع مشابه
Thick Film Resistors Ndt by Electro-ultrasonic Spectroscopy
The non-linear electro-ultrasonic spectroscopy was used as a non-destructive testing method for the polymer based and cermet thick film resistors evaluation. We carried out the correlation between this method and standard testing methods as noise spectroscopy and the third harmonic voltage measurements. The measuring set-up with the ultrasonic transducer working on the frequency range 10 kHz to...
متن کاملA Pzt Multilayer Thick-film Actuator for Ultrasonic Applications
In many MEMS applications there is a requirement for actuating a structure. This paper describes a method of generating acoustic power from a PZT based thick-film structure which gives output power and electrical efficiencies at least as good as, and in some cases better than bulk PZT in the same application.
متن کاملIn vivo photoacoustic microscopy with 7.6-µm axial resolution using a commercial 125-MHz ultrasonic transducer.
Photoacoustic microscopy has achieved submicron lateral resolution, but its axial resolution is much lower. Here an axial resolution of 7.6 μm, the highest axial resolution validated by experimental data, has been achieved by using a commercial 125 MHz ultrasonic transducer for signal detection followed by the Wiener deconvolution for signal processing. Limited by the working distance, the high...
متن کاملDesign and Fabrication of a Longitudinal-Torsional Ultrasonic Transducer
A hybrid longitudinal-torsional ultrasonic transducer is designed and fabricated in this research. The design of the transducer was performed using the FE method with ABAQUS software, with the aim of combining the longitudinal and torsional vibration modes. The transducer horn is then fabricated using a 4-axis milling machine. The PZT stacks are employed in order to excite the transducer. The t...
متن کاملDesign and Fabrication of a Longitudinal-Torsional Ultrasonic Transducer
A hybrid longitudinal-torsional ultrasonic transducer is designed and fabricated in this research. The design of the transducer was performed using the FE method with ABAQUS software, with the aim of combining the longitudinal and torsional vibration modes. The transducer horn is then fabricated using a 4-axis milling machine. The PZT stacks are employed in order to excite the transducer. The t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
سال: 2018
ISSN: 0885-3010,1525-8955
DOI: 10.1109/tuffc.2018.2865791