Scale Formation Due to Water Injection in Malaysian Sandstone Cores
نویسندگان
چکیده
منابع مشابه
simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Experimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow
The study of two-phase fluid flow behavior in hydraulic structures such as pressurized flow tunnels, culverts, sewer pipes, junctions and other similar conduits is of great importance. A two-phase mixture flowing in a pipe can exhibit several interfacial geometries such as bubbles, slugs or films, depending on the fluid and hydrodynamic properties of flow. The main variables, giving rise to a v...
متن کاملAn Experimental Study of CO2-low Salinity Water Alternating Gas Injection in Sandstone Heavy Oil Reservoirs
Several studies have shown that oil recovery significantly increased by low salinity water flooding (LSWF) in sandstones. However, mechanism of oil recovery improvement is still controversial. CO2 that develops buffer in presence of water is expected as a deterrent factor in LSWF efficiency based on mechanism of IFT reduction due to pH uprising. No bright evidence in literature suppo...
متن کاملExperimental Results of Pressure Fluctuations in a Water Conduit Section Due to Formation of Unstable Two-Phase Air-Water Flow
The study of two-phase fluid flow behavior in hydraulic structures such as pressurized flow tunnels, culverts, sewer pipes, junctions and other similar conduits is of great importance. A two-phase mixture flowing in a pipe can exhibit several interfacial geometries such as bubbles, slugs or films, depending on the fluid and hydrodynamic properties of flow. The main variables, giving rise to a v...
متن کاملAn Experimental Investigation of Different Formation Waters and Injection Water Incompatibility to Obtain the Optimum Water Mixing Ratio in Injection Processes
Scale formation and well plugging due to the incompatibility of injected waters is a critical field problem in oil recovery. A water injection process was successfully performed when the identification of the source of water, water quality considerations, and laboratory compatibility tests were considered. When different waters are mixed, it is necessary to evaluate their compatibility prior to...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: American Journal of Applied Sciences
سال: 2009
ISSN: 1546-9239
DOI: 10.3844/ajassp.2009.1531.1538