Running-in Behavior of Repeated Dry Wear on Metals.
نویسندگان
چکیده
منابع مشابه
Finite-element modeling of dry sliding wear in metals
This paper is concerned with the calibration and validation of a finite-element model of dry sliding wear in metals. The model is formulated within a Lagrangian framework capable of accounting for large plastic deformations and history-dependent material behavior. We resort to continuous adaptive meshing as a means of eliminating deformation-induced element distortion, and of resolving fine fea...
متن کاملDry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملEffect of Wet and Dry Conditions on Wear Behavior of Amorphous Coating of Fe-Cr-Mo-Nb-C-B
Recently, wear resistant properties of metallic glasses has attracted a lot of interest. Because the surface of metallic glasses are prone to phase transformation, finding the effects of test condition on structure and wear behavior of metallic glasses is important. In this research, by using an automated electrospark deposition (ESD), a layer of Fe51Cr18Mo7B16C4Nb4 was deposited on AISI 316l s...
متن کاملDry Wear Behavior of 42CrMo4 Steel/ZrO2 Composite Prepared by Pressure-Less Infiltration Method
The aim of this research was to study the wear behavior of 42CrMo4 steel/ZrO2 composite with 10 and 30 ppi performed ceramic and compare it with the un-reinforced steel under different applied loads. The composite specimens were obtained by pressureless infiltration of the melt into a preformed ceramic of zirconium oxide. The effect of applied load on the specimens wear behavior was ...
متن کاملThe Relation between Wear and Irreversible Entropy Generation in the Dry Sliding of Metals
This paper examines the relationship between wear and the generation of entropy within the mechanically affected zone, MAZ, of a sliding material. It is postulated that wear is related to irreversible entropy generation within the MAZ. This accumulation takes a place due to the degradation in the ability of the rubbing material to maintain a noncongested flow of the generated entropy. This, in ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Society of Materials Engineering for Resources of Japan
سال: 1998
ISSN: 1884-6610,0919-9853
DOI: 10.5188/jsmerj.11.2_12