RUN TIME DYNAMIC PARTIAL RECONFIGURATION USING MICROBLAZE SOFT CORE PROCESSOR FOR DSP APPLICATIONS
نویسندگان
چکیده
منابع مشابه
Run Time Dynamic Partial Reconfiguration Using Microblaze Soft Core Processor for Dsp Applications
DSP Application requires a fast computations & flexibility of the design. Partial Reconfiguration (PR) is an advanced technique, which improves the flexibility of FPGAs by allowing portions of a design to be reconfigured at runtime by overwriting parts of the configuration memory. In this paper we are using microblaze soft core processor & ICAP Port to reconfigure the FPGA at runtime. ICAP is a...
متن کاملUltra-Low-Energy DSP Processor Design for Many-Core Parallel Applications
Background and Objectives: Digital signal processors are widely used in energy constrained applications in which battery lifetime is a critical concern. Accordingly, designing ultra-low-energy processors is a major concern. In this work and in the first step, we propose a sub-threshold DSP processor. Methods: As our baseline architecture, we use a modified version of an existing ultra-low-power...
متن کاملPartial Run-Time Reconfiguration Using JRTR
Much has been written about the design and performance advantages of partial Run-Time Reconfiguration (RTR) over the last decade. While the results have been promising, commercial support for partial RTR has lagged. Until the introduction of the Xilinx Virtex family of devices, no mainstream, commercial FPGA has provided support for this capability. In this paper we describe JRTR, a software pa...
متن کاملAdvances and Trends in Dynamic Partial Run-time Reconfiguration
Partial runtime reconfiguration allows to fit circuits on an FPGA that would exceed the device capacity in a static only implementation. This implementation technique is only applicable if the system contains modules with mutual exclusive functionality or if the utilization of some modules allow time-multiplexing of the same FPGA resources. For example, as illustrated in Figure 1, in an FPGA-ba...
متن کاملUsing run-time reconfiguration for fault injection applications
The probability of faults occurring in the field increases with the evolution of the CMOS technologies. It becomes, therefore, increasingly important to analyze the potential consequences of such faults on the applications. Fault injection techniques have been used for years to validate the dependability level of circuits and systems, and approaches have been proposed to analyze very early in t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2013
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2013.0212027