Rubber plunger surface texturing for friction reduction in medical syringes
نویسندگان
چکیده
منابع مشابه
Optimum dimple diameter for friction reduction with laser surface texturing: the effect of velocity gradient
This paper describes the modelling and testing of mm-scale hydrodynamic bearings which are being developed to improve the efficiency of a cm-scale turbine energy harvester, whose efficiency was previously limited by poorly lubricated commercial jewel-bearings. The bearings were fabricated using DRIE and their performance was assessed using a custom built MEMS tribometer. Results demonstrate tha...
متن کاملRubber friction and tire dynamics.
We propose a simple rubber friction law, which can be used, for example, in models of tire (and vehicle) dynamics. The friction law is tested by comparing numerical results to the full rubber friction theory (Persson 2006 J. Phys.: Condens. Matter 18 7789). Good agreement is found between the two theories. We describe a two-dimensional (2D) tire model which combines the rubber friction model wi...
متن کاملRubber Friction in Aqueous Solutions Containing Ions
Lubricants ordinarily operate by keeping two sliding surfaces separated. The efficiency of a lubricant may be expressed by equations of hydrodynamics where the mechanical properties of the films of lubricants are adequately defined by the properties of bulk lubricant. In the case of water lubrication of black rubber at slow speeds and low pressures the lubricating ability of water is shown to b...
متن کاملReducing the Magnetic Tape/guide Friction Coefficient by Laser Surface Texturing: Experimental Analysis
The friction coefficient is an important parameter in designing magnetic tape transports. We have introduced laser surface texturing to reduce the friction coefficient between guides and magnetic tape. The surface features enhance the formation of an air bearing and hence, reduce the friction coefficient. INTRODUCTION Lateral tape motion (LTM) is defined as the time-dependent motion of the tape...
متن کاملFriction reduction in lubricated-MEMS with complex slip surface pattern
Many types of micro-electro-mechanical-system (MEMS) based products are currently employed in a variety of applications. However, high friction in these systems is a problem which limits the development of MEMS devices in which sliding contacts are involved. The aim of this research is to evaluate the effect of boundary slip on the hydrodynamic friction in a low load lubricated MEMS, in particu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Friction
سال: 2018
ISSN: 2223-7690,2223-7704
DOI: 10.1007/s40544-018-0227-5