Rotating Bending Fatigue Test of Large Press-Fitted Shaft under Two-Step Pulsating Load

Design and Test of a Large Two-Shaft Gas Turbine

The largest two-shaft gas turbine in the United States has been operated in combined cycle service at the Oklahoma Gas and Electric Company Horseshoe Lake Station since May 1963. The same design unit has been operated in peaking and stand-by service at Public Service Electric and Gas (Essex, N. J.) station since December 1963. The 0.G & E. unit has a NEMA rating of 25 Mw base load. The PSEG uni...

Assessment of different methods for fatigue life prediction of steel in rotating bending and axial loading

Generally, fatigue failure in an element happens at the notch on a surface where the stress level rises because of the stress concentration effect. The present paper investigates the effect of a notch on the fatigue life of the HSLA100 (­high strength low alloy) steel which is widely applicable in the marine industry. Tensile test was conducted on specimens and mechanical properties were obtain...

Damage Detection of Carbon Fiber-reinforced Concrete Under Bending Test

Trigonometrically fitted two-step obrechkoff methods for the numerical solution of periodic initial value problems

In this paper, we present a new two-step trigonometrically fitted symmetric Obrechkoff method. The method is based on the symmetric two-step Obrechkoff method, with eighth algebraic order, high phase-lag order and is constructed to solve IVPs with periodic solutions such as orbital problems. We compare the new method to some recently constructed optimized methods from the literature. The numeri...

assessment of different methods for fatigue life prediction of steel in rotating bending and axial loading

generally, fatigue failure in an element happens at the notch on a surface where the stress level rises because of the stress concentration effect. the present paper investigates the effect of a notch on the fatigue life of the hsla100 (­high strength low alloy) steel which is widely applicable in the marine industry. tensile test was conducted on specimens and mechanical properties were obtain...