Room-Temperature Deformation and Martensitic Transformation of Two Co-Cr-Based Alloys

Martensitic Transformation in Ni-Mn-Sn-Co Heusler Alloys

Thermal and structural austenite to martensite reversible transition was studied in melt spun ribbons of Ni50Mn40Sn5Co5, Ni50Mn37.5Sn7.5Co5 and Ni50Mn35Sn10Co5 (at. %) alloys. Analysis of X-ray diffraction patterns confirms that all alloys have martensitic structure at room temperature: four layered orthorhombic 4O for Ni50Mn40Sn5Co5, four layered orthorhombic 4O and seven-layered monoclinic 14...

The Correlations between the Eutectoid Transformation, Order-Disorder Transformation, and Martensitic Transformation in Cu3Al Binary Alloys

In view of the fact that three kinds of phase transformations, i.e. aneutectoid decomposition β→ α+γ2, an ordering transformation β→ β1, and a martensitic transformation β1→ β' have been observed on isothemlal holding and cooling at different rates from the β region in Cu-Al binary alloys, the author has tried to obtain the T/T/T diagrams in order to show the correlations between these three tr...

Analysis of deformation induced martensitic transformation in stainless steels

Many studies monitoring the formation of martensite during the tensile deformation of austenite report data which are, in principle, affected by both the applied stress and the resulting plastic strain. It is not clear in these circumstances whether the transformation is stress induced (i.e. the stress provides a mechanical driving force) or whether the generation of defects during deformation ...

Martensitic Transformation in Microcrystalline Melt-Quenched Fe-Ni Alloys

The features of martensite transformation in Fe (31 32)% Ni melt-quenched alloys are considered. The meltquenching was realized by spinning technique with variable parameters. The influence of the melt-quenching on structural and kinetics transformation parameters is revealed. In particular Ms point is shown to decrease but volume percentage of athermal martensite is found to be invariable with...

EXAFS IN CuZn BRASS ALLOYS DURING MARTENSITIC TRANSFORMATION