Rock characterization while drilling and application of roof bolter drilling data for evaluation of ground conditions
نویسندگان
چکیده
منابع مشابه
Application of Fast Dynamic Allan Variance for the Characterization of FOGs-Based Measurement While Drilling
The stability of a fiber optic gyroscope (FOG) in measurement while drilling (MWD) could vary with time because of changing temperature, high vibration, and sudden power failure. The dynamic Allan variance (DAVAR) is a sliding version of the Allan variance. It is a practical tool that could represent the non-stationary behavior of the gyroscope signal. Since the normal DAVAR takes too long to d...
متن کاملRock fragmentation and optimization of drilling tools
In this chapter possibilities of the improvement of drilling tool efficiency on the basis of the analysis of mechanisms of rock destruction and some methods of the information theory are considered. Physical mechanisms of destruction of hard and plastic rocks under different conditions of mechanical loading are reviewed. Some physical effects which allow to improve the efficiency of rock drilli...
متن کاملThermal Response Test While Drilling
Knowledge of the ground thermal conductivity is of importance when designing borehole heat exchanger (BHE) systems. As thermal conductivity for any specific rock type varies due to its mineral content, porosity, pore fluid and anisotropy, it is preferable determined in-situ. Choudhary (1976) suggested a method for determining the thermal conductivity which analysed the heat transfer during the ...
متن کاملDPCM Compression for Real-Time Logging While Drilling Data
Logging while drilling (LWD) is a drilling technique which obtains and transmits the logging data during oil/gas drilling operations. Because of the limited available transmission bandwidth of mud channel, how to improve the bandwidth utilization becomes a critical problem in LWD research. In this paper, by discussing the information entropy of real logging data, we find that the original encod...
متن کاملDrilling Cost per Unit Volume of Removed Rock - a Criterium of Optimization of Drilling
An approach to the optimization of drilling tools which is based on the analysis of dependence of drilling cost on the tool shape is presented. The effect of tool shape on the energy consumption in rotatory drilling and on the lifetime of tool is studied analytically. It is shown that the main part of drilling energy is consumed not for the rock removal, but rather by the microfracture, shearin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Rock Mechanics and Geotechnical Engineering
سال: 2015
ISSN: 1674-7755
DOI: 10.1016/j.jrmge.2015.01.006