RMS Voltage Measurements by Thermal Converter with Temperature Controlled
نویسندگان
چکیده
منابع مشابه
A Temperature Compensation Voltage Controlled Oscillator Using a Complementary to Absolute Temperature Voltage Reference
This paper presents a temperature compensation voltage controlled oscillator (VCO) based on Cross-Coupled pair and Colpitts structures which is suitable for military fields. Also, two inductors have been used for increasing the negative conductance. By using this method, start-up condition has been improved. Two varactors and a simple capacitor bank are applied for covering a wide tunning range...
متن کاملBulk micromachined electrostatic RMS-to-DC converter
Bulk micromachining in silicon and glass wafers and subsequent silicon-to-glass anodic bonding have been used for the realization of an electrostatic rms-to-dc converter. A suspended membrane has been designed for: large dynamic operating range (detection limit by minimum mechanical-thermal noise and high value of the pull-in voltage), maximum bandwidth (low series resistance, high second harmo...
متن کاملDynamic translinear RMS-DC converter - Electronics Letters
Introduction: One of the possible techniques to cope with the restrictions imposed by llow supply voltages is instantaneous companding [l], which is an inherent characteristic of translinear (TL) filters [2], also called exponential state-space filters [3]. TL filters exploit the exponential large-signal behaviour of the bipolar, or weak inversion MOS, transistor both for an expanding capacitan...
متن کاملA New Low-Voltage RMS Converter based on Current Conveyors in MOS Technology
In this paper, a new current mode true RMS-to-DC converter circuit using second generation current conveyors (CCII) is presented. The second generation current conveyor employs MOSFET transistors that are operating in strong inverted saturation region. The proposed methodology provides the following advantages: a complete current-mode circuit makes it suitable for current-mode signal processing...
متن کاملEVALUATING THERMAL ENVIRONMENTS BY USING A THERMAL MANiKiN WiTH CONTROLLED SKiN SURFACE TEMPERATURE
This paper describes a method for measuring nonuniform thermal environments using a new thermal manikin with controlled skin surface temperature. The manikin its control logic are described, and an equivalent temperature based on the therntal manikin (teq) is proposed and discussed. A method to calculate the PMV index from manikin heat loss is also given. To calibrate these methods, fundamental...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Electronics, Information and Systems
سال: 1999
ISSN: 0385-4221,1348-8155
DOI: 10.1541/ieejeiss1987.119.7_911