Riveting Process Modeling and Simulating for Deformation Analysis of Aircraft's Thin-walled Sheet-metal Parts
نویسندگان
چکیده
منابع مشابه
Three-dimensional localization of thin-walled sheet metal parts for robotic assembly
This article presents a technical demonstration of a system for determining the threedimensional spatial location of complexly shaped, thin-walled sheet metal parts grasped by robots during assembly. For successful part assembly, the precise location of grasped parts (essential for successful mating of parts) must be achieved. A localization system is implemented to determine the accurate posit...
متن کاملAnalysis of the Rotary-draw Bending Process for Thin-walled Rectangular Aluminum Tube
The Rotary-Draw Bending (RDB) process is a distinguished process employed for the precision cold bending of a hollow tube with small radius bends using Numerical Control (NC) machines. This research presents an analytical model based on the power law hardening model for the RDB processing of rectangular thin tubes. Based on the constraints of the tube in the dies and its thinness, the plane str...
متن کاملLayered Manufacturing of Thin-walled Parts
We describe a new algorithm we have developed for making partially hollow layered parts with thin, dense walls of approximately uniform thickness, for faster build times and reduced material usage. We have implemented our algorithm on a fused deposition modeling (FDM) machine, using separate build volumes for a loosely filled interior and a thin, solid, exterior wall. The build volumes are deri...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملOn the Topology of Sheet Metal Parts
Abstract This paper analyzes the topological properties of sheet metal parts represented schematically (zero thickness, zero bend radii). Although such parts are usually non-manifold objects, the paper establishes a general topological invariant f = s + b + e + w v gnm + m regarding the number of facets, components, bends, free edges, welds, vertices holes and volumes, respectively. Correspondi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chinese Journal of Aeronautics
سال: 2011
ISSN: 1000-9361
DOI: 10.1016/s1000-9361(11)60044-7