Resistively Switching Chalcogenides
نویسندگان
چکیده
منابع مشابه
A resistively heated CeB6 emissive probe.
The plasma potential, V(p), is a key quantity in experimental plasma physics. Its spatial gradients directly yield the electrostatic field present. Emissive probes operating under space-charge limited emission conditions float close to V(p) even under time-varying conditions. Throughout their long history in plasma physics, they have mostly been constructed with resistively heated tungsten wire...
متن کاملChalcogenides as organocatalysts.
In this review, we describe the many roles chalcogenides play as organocatalysts. Chalcogens, or the oxygen family, * To whom correspondence should be addressed. Phone: +00-44-1179546315. Fax: +00-44-117-9298611. E-mail: [email protected]. † University of Bristol. ‡ Current Address: Department of Biochemistry, University of Wisconsins Madison, 433 Babcock Drive, Madison, Wisconsin 53706-...
متن کاملResistively Loaded Discones for Uwb Communications
An Ultra-Wideband (UWB) antenna is required for UWB communications systems, such as the Joint Tactical Radio System (JTRS). In this case, the desired antenna must cover a bandwidth of 20 MHz to 4 GHz, be omnidirectional, be convenient to transport and deploy, and be able to transmit 200 Watts of power. Conventional discone antennas are candidates for such systems, but they have insufficient ban...
متن کاملRevisiting some chalcogenides for thermoelectricity.
Thermoelectric materials that are efficient well above ambient temperature are needed to convert waste-heat into electricity. Many thermoelectric oxides were investigated for this purpose, but their power factor (PF) values were too small (∼10-4 W m-1 K-2) to yield a satisfactory figure of merit zT. Changing the anions from O2- to S2- and then to Se2- is a way to increase the covalency. In this...
متن کاملMethod for Attaching Fluidic Interconnects using Resistively Heated Gold
Two methods of attaching fluidic interconnects are presented. By using gold to gold fusion bonding and copper to gold fusion bonding, micro-scale tubes are attached to a MUMPS fabricated fluidic channel. The fusion bonding is done by resistively heating a gold layer on top of the poly 2 layer, so that the gold melts. A range of different heater geometries is presented. The tensile and shear str...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Functional Materials
سال: 2015
ISSN: 1616-301X
DOI: 10.1002/adfm.201503288