Resin flow analysis during RTM Manufacturing of GFRP composites containing embedded impermeable inserts
نویسندگان
چکیده
منابع مشابه
Curing of Polymeric Composites Using Microwave Resin Transfer Moulding (rtm)
The main objective of this work is to compare the difference between microwave heating and conventional thermal heating in fabricating carbon/epoxy composites. Two types of epoxy resin systems were used as matrices, LY5052-HY5052 and DGEBA-HY917-DY073. All composite samples were fabricated using resin transfer moulding (RTM) technique. The curing of the LY5052-HY5052-carbon and the DGEBA-HY917-...
متن کاملCuring Behavior of Thick-sectioned Rtm Composites
The successful manufacture of thick-sectioned composites is challenging, since the highly exothermic nature of thermoset resins and limited temperature control make it difficult to avoid detrimental thermal and cure gradients within the composite. In order to make quality parts, it has been found experimentally that cure temperatures must be lowered as much as 50% from those suggested for thin ...
متن کاملFlow, strength, stiffness and radiopacity of flowable resin composites.
OBJECTIVE This study was undertaken to characterize 9 currently available proprietary flowable composites with respect to key properties of flow, flexural strength, stiffness (modulus of elasticity) and radiopacity. METHODS Seven proprietary flowable composites (Aelite Flo, Filtek Flow, Heliomolar Flow, PermaFlo, Revolution Formula 2, Tetric Flow, Wave) and 2 flowable compomers (Compoglass Fl...
متن کاملA Numerical Investigation of the Resin Flow Front Tracking Applied to the RTM Process
Escola de Engenharia , Universidade Federal de Rio Grande – FURG, Av. Itália, Km 08, s/n, Campus Carreiros, CEP 96201-900, Rio Grande, RS, Brazil Departamento de Engenharia de Materiais, Universidade Federal do Rio Grande do Sul – UFRGS, Av. Bento Gonçalves, 9500, CEP 91501-970, Porto Alegre, RS, Brazil Departamento de Engenharia Mecânica, Universidade Federal do Paraná – UFPR, CP 19011, CEP 81...
متن کاملPotentiality of Optical Fibre Bragg Grating Sensors for Resin Transfer Moulding Process Monitoring
Resin transfer moulding (RTM) is a widely used process for manufacturing composite parts. It is currently gaining market shares compared to autoclave process in particular for high performance applications, such as aerospace, thanks to its higher versatility permitting the manufacturing of complex and high quality composite parts in fairly short cycle times. The major disadvantage of RTM remain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Research, Society and Development
سال: 2021
ISSN: 2525-3409
DOI: 10.33448/rsd-v10i6.15362