Resin composites top/bottom hardness and different light cure
نویسندگان
چکیده
منابع مشابه
Effect of pre-heating on depth of cure and surface hardness of light-polymerized resin composites.
PURPOSE To evaluate the depth of cure and surface hardness of two resin composites when subjected to three preheating temperatures, three polymerization times and two types of curing lights. METHODS Two resin composites were used in this study (Esthet-X and TPH), three polymerization times (10, 20, 40 seconds), three preheating temperatures (70, 100, 140 degrees F/21.1, 37.7 and 60 degrees C)...
متن کاملHardness of composite resin polymerized with different light-curing units
Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light ...
متن کاملHardness of composite resin polymerized with different light-curing units
Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light cur...
متن کاملcomparative depth of cure among two light-cured core build-up composites by surface vickers hardness.
depth of cure of composite material is restricted and it depends on many parameters such as thickness. the aim of this in-vitro study was to evaluate the depth of cure of two light-cured core build-up composites (quixfil and photocore) in different thicknesses, when cured for 60 seconds.the vickers microhardness measurements were made for each side of the top irradiated surfaces of 1,2,3,4,5,6,...
متن کاملConversion degrees of resin composites using different light sources
OBJECTIVE The objective of this study was to compare the conversion degree of six different composite materials (Filtek Z 250, Filtek P60, Spectrum TPH, Pertac II, Clearfil AP-X, and Clearfil Photo Posterior) using three different light sources (blue light-emitting diode [LED], plasma arc curing [PAC], and conventional halogen lamp [QTH]). METHODS Composites were placed in a 2 mm thick and 5 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Asian pacific journal of dentistry
سال: 2021
ISSN: ['2185-3487', '2185-3479']
DOI: https://doi.org/10.47416/apjod.21-0282