Residual Stress Measurement with Laser-Optical and Mechanical Methods
نویسندگان
چکیده
منابع مشابه
Residual Stress Analysis Based on Acoustic and Optical Methods
Co-application of acoustoelasticity and optical interferometry to residual stress analysis is discussed. The underlying idea is to combine the advantages of both methods. Acoustoelasticity is capable of evaluating a residual stress absolutely but it is a single point measurement. Optical interferometry is able to measure deformation yielding two-dimensional, full-field data, but it is not suita...
متن کاملMeasurement of residual stress using laser-generated ultrasound
Most manufacturing processes result in residual stress. The level of residual stress can be high and could affect the structural integrity of the component. Without knowledge of the residual stress field, assessments are often overly conservative. There are many techniques available for residual stress measurement. Mechanical methods, such as centre-hole drilling, have been extensively used but...
متن کاملDefect Detection and Residual Stress Measurement in Friction Stir Welds using Laser Ultrasonics
The laser-ultrasonic technique is proposed for defect detection and residual stress measurement in friction stir welds (FSW). When combined with the synthetic aperture focusing technique (F-SAFT), very good performances are achieved for detecting lack of penetration in butt joints, the detection limit coinciding with the conditions of reduced mechanical properties. Also, the detection of kissin...
متن کاملOverview Residual stress Part 1 – Measurement techniques
Residual stress is that which remains in a body that is stationary and at equilibrium with its surroundings. It can be very detrimental to the performance of a material or the life of a component. Alternatively, beneficial residual stresses can be introduced deliberately. Residual stresses are more difficult to predict than the in-service stresses on which they superimpose. For this reason, it ...
متن کاملLaser beam quality and pointing measurement with an optical resonator.
We present a compact diagnostic breadboard that is based on an optical ring resonator for measuring beam quality and pointing of single-frequency continuous wave lasers at a wavelength of 1064 nm. To determine the beam quality of the coherent test beam, this optical resonator is used to perform a mode decomposition into Hermite-Gaussian modes. For our laser system, a power fraction in the funda...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advanced Materials Research
سال: 2014
ISSN: 1662-8985
DOI: 10.4028/www.scientific.net/amr.996.256