Residual stress field in steel samples during plastic deformation and recovery processes
نویسندگان
چکیده
منابع مشابه
Characterization of residual stresses generated during inhomogeneous plastic deformation
Residual stresses generated by macroscopic inhomogeneous plastic deformation are predicted by an explicit finite element (FE) technique. The numerical predictions are evaluated by characterizing the residual elastic strains by neutron diffraction using two different (hkl ) reflections. Intergranular residual elastic strains between subsets of grains are predicted numerically and verified by neu...
متن کاملThermoelastic investigation of residual stress: plastic deformation and the change in thermoelastic constant
Plastic deformation causes very small changes in the thermoelastic response of metallic materials; this variation of the thermoelastic constant has the potential to form the basis of a new non-destructive, non-contact, full-field technique for residual stress assessment that is quicker and cheaper than existing methods. The effect of plastic strain on the thermoelastic constant is presented as ...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
correlation between twinning and surface rumpling phenomenon during plastic deformation of austenitic manganese steel
in this paper, the correlation between the surface rumpling and cracking phenomena with twinning mechanism during plastic deformation of hadfield steel has been investigated. the effect of stacking fault energy and the amount of strain are evaluated. the experimental samples with specific amounts of carbon, manganese and aluminum resulting in different stacking fault energies, were produced usi...
متن کاملModelling, Simulation and Validation of Plastic Zone Size during Deformation of Mild Steel
Abstract—A model to predict the plastic zone size for material under plane stress condition has been developed and verified experimentally. The developed model is a function of crack size, crack angle and material property (dislocation density). Simulation and validation results show that the model developed show good agreement with experimental results. Samples of low carbon steel (0.035%C) wi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Philosophical Magazine
سال: 2011
ISSN: 1478-6435,1478-6443
DOI: 10.1080/14786435.2011.557401