Residual Stress Distribution of Asymmetric Quenching in Al-Zn-Mg-Cu Aluminum Alloy Plate
نویسندگان
چکیده
منابع مشابه
Precipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy.
A previously undescribed high aspect ratio strengthening platelet phase, herein named the Y-phase, has been identified in a commercial Al-Zn-Mg-Cu alloy. Differential scanning calorimetry indicates that this phase only precipitates at temperature and cooling rate of about 150-250 °C and 0.05-300 K/s, respectively. This precipitate is shown to be responsible for a noticeable improvement in mecha...
متن کاملPrecipitation Behavior and Quenching Sensitivity of a Spray Deposited Al-Zn-Mg-Cu-Zr Alloy
Precipitation behavior and the quenching sensitivity of a spray deposited Al-Zn-Mg-Cu-Zr alloy during isothermal heat treatment have been studied systematically. Results demonstrate that both the hardness and the ultimate tensile strength of the studied alloy decreased with the isothermal treatment time at certain temperatures. More notably, the hardness decreases rapidly after the isothermal h...
متن کاملnumerical simulation of residual stress distribution in al alloy plate after a cold rolling process
0
متن کاملQuench Rate Effects on the Natural Aging Behavior of 7xxx Al-mg-zn-cu Aluminum Alloys
The effect of quench rate on the natural aging behavior was examined using microhardness, conductivity and the differential scanning calorimeter. The data indicated that GPZ formed during extended natural aging of 7075, while extended aging of 7050 resulted in the precipitation of η’. Introduction The aluminum alloy system Al-Zn-Mg-Cu is the mainstay of aluminum alloys used in the aerospace ind...
متن کاملMicrostructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
The hot deformation behavior and microstructural evolution of an Al-Zn-Mg-Cu (7150) alloy was studied during hot compression at various temperatures (300 to 450 °C) and strain rates (0.001 to 10 s-1). A decline ratio map of flow stresses was proposed and divided into five deformation domains, in which the flow stress behavior was correlated with different microstructures and dynamic softening m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Materials Science and Chemical Engineering
سال: 2021
ISSN: 2327-6045,2327-6053
DOI: 10.4236/msce.2021.94002