Residual Stress Analysis of Dissimilar Weld Joint between CastIron Pipe and Steel Flange
نویسندگان
چکیده
منابع مشابه
A Stress Analysis of Pipe Flange Connections
The use of pipe flange connections is standardized in the codes of JIS, ASME, DIN and so on. However, these codes are almost entirely dependent on experience, and subsequently some problems concerning pipe flange connections have been encountered. In the present paper, the distribution of contact stresses which governs the sealing performance is analyzed as a three-body contact problem, using a...
متن کاملI / RESIDUAL STRESS DISTRIBUTION IN FeAl WELD OVERLAY ON STEEL
Neutron diffraction was used to measure the residual stress distribution in an FeAl weld overlay on steel. It was found that the residual stresses accumulated during welding were essentially removed by the post-weld heat treatment that was applied to the specimen; most residual stresses in the specimen developed during cooling following the post-weld heat treatment. The experimental data were c...
متن کاملWeld Quality Prediction of Mild Steel Pipe Joint during Shielded Metal Arc Welding through fuzzy Logic
The present paper describes fuzzy logic simulation of shielded metal arc welding (SMAW) process to predict the Quality of weld joint. It describe the quality of weld joint & effect of welding current, voltage and welding speed on tensile strength of shielded metal arc pipe welded mild steel joints. An ERW Mild steel pipe I S 1239 of 6 mm thickness and 150 mm diameter were used as the base mater...
متن کاملWelding Residual Stress Analysis and Fatigue Strength Assessment of Multi-Pass Dissimilar Material Welded Joint between Alloy 617 and 12Cr Steel
The reliability of welded structure can be evaluated through welding residual stress analysis and fatigue strength assessment. In this study, welding residual stresses of multi-pass dissimilar material welded joint between alloy 617 and 12Cr steel were analyzed numerically and experimentally. Fatigue strength was then assessed in the air. Based on results of welding residual stress analysis and...
متن کاملResidual Stress Characterization in a Dissimilar Metal Weld Nuclear Reactor Piping System Mock Up
Time-of-flight neutron diffraction, contour method, and surface hole drilling residual stress measurements were conducted at Los Alamos National Lab (LANL) on a lab sized plate specimen (P4) from Phase 1 of the joint U.S. Nuclear Regulatory Commission and Electric Power Research Institute Weld Residual Stress (NRC/EPRI WRS) program. The specimen was fabricated from a 304L stainless steel plate ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: QUARTERLY JOURNAL OF THE JAPAN WELDING SOCIETY
سال: 2020
ISSN: 0288-4771,2434-8252
DOI: 10.2207/qjjws.38.144s