Residual stress analysis of all perovskite oxide cantilevers
نویسندگان
چکیده
منابع مشابه
All-inorganic inverse perovskite solar cells using zinc oxide nanocolloids on spin coated perovskite layer
We confirmed the influence of ZnO nanoparticle size and residual water on performance of all inorganic perovskite solar cells. By decreasing the size of the ZnO nanoparticles, the short-circuit current density (Jsc) and open circuit photovoltage (Voc) values are increased and the conversion efficiency is improved. Although the Voc value is not affected by the influence of residual water in the ...
متن کاملThe Microscopic Origin of Residual Stress for Flat Self-Actuating Piezoelectric Cantilevers
In this study, flat piezoelectric microcantilevers were fabricated under low-stress Pb(Zr0.52Ti0.48)O3 (PZT) film conditions. They were analyzed using the Raman spectrum and wafer curvature methods. Based on the residual stress analysis, we found that a thickness of 1 μm was critical, since stress relaxation starts to occur at greater thicknesses, due to surface roughening. The (111) preferred ...
متن کاملEpitaxial growth of highly-crystalline spinel ferrite thin films on perovskite substrates for all-oxide devices
The potential growth modes for epitaxial growth of Fe3O4 on SrTiO3 (001) are investigated through control of the energetics of the pulsed-laser deposition growth process (via substrate temperature and laser fluence). We find that Fe3O4 grows epitaxially in three distinct growth modes: 2D-like, island, and 3D-to-2D, the last of which is characterized by films that begin growth in an island growt...
متن کاملEnergy harvesting properties of all-thin-film multiferroic cantilevers
We have measured electromagnetic energy harvesting properties of all-thin-film magnetoelectric (ME) heterostructures on Si cantilevers. The devices are built on a silicon oxide/nitride/oxide stack, and the ME layers consist of a magnetostrictive Fe0.7Ga0.3 thin film and a Pb(Zr0.52Ti0.48)O3 piezoelectric thin film. The harvested peak power at 1 Oe is 0.7 mW/cm (RMS) at the resonant frequency (3...
متن کاملResidual stress analysis in thick uranium films
Residual stress analysis was performed on thick, 1–25 lm, depleted uranium (DU) films deposited on an Al substrate by magnetron sputtering. Two distinct characterization techniques were used to measure substrate curvature before and after deposition. Stress evaluation was performed using the Benabdi/Roche equation, which is based on beam theory of a bi-layer material. The residual stress evolut...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electroceramics
سال: 2011
ISSN: 1385-3449,1573-8663
DOI: 10.1007/s10832-011-9663-6