RESIDUAL STRENGTH CHARACTERISTICS OF SOFT ROCKS WITH A DISCONTINUOUS PLANE
نویسندگان
چکیده
منابع مشابه
A Critical Plane Approach to Anisotropic Strength of Rocks
The paper is concerned with the derivation of failure criteria for anisotropic materials through a simple extension of the Mohr Coulomb failure criterion and embracing the critical plane concept. We revisit the classic problem of determining the macroscopic strength of a rock specimen with an initial structural anisotropy in relation to the directions of externally applied principal stresses. M...
متن کاملProposals for a Failure Criterion Applicable to Discontinuous Rocks
The existing failure criteria to evaluate discontinuous rocks are predominatly based on the relations between principal stresses at failure. None of the criteria has a direct reference to the magnitude of deformation as a major parameter in rock Several reasons are identified indicating that the selection of peak stress as a major parameter, which is obtained through the evaluation of a failure...
متن کاملDeformational Characteristics of Rocks Containing a Single Discontinuity (TECHNICAL NOTE)
For the purpose of exploring deformation characteristics of jointed rock masses, influence of joint inclination and confining pressure on the mechanical behavior of discontinuous rock a series of compression tests were conducted under satisfactory testing conditions on three types of sandstone from various locations. Three groups of jointed specimens were used in this research, including specim...
متن کاملPlane Wave Discontinuous Galerkin Methods
Standard low order Lagrangian finite element discretization of boundary value problems for the Helmholtz equation −∆u−ωu = f are afflicted with the so-called pollution phenomenon: though for sufficiently small hω an accurate approximation of u is possible, the Galerkin procedure fails to provide it. Attempts to remedy this have focused on incorporating extra information in the form of plane wav...
متن کاملPoroelastic fluid effects on shear for rocks with soft anisotropy
A general analysis of poroelasticity for vertical transverse isotropy (VTI) shows that four eigenvectors are pure shear modes with no coupling to the pore-fluid mechanics. The remaining two eigenvectors are linear combinations of pure compression and uniaxial shear, both of which are coupled to the fluid mechanics. After reducing the problem to a 2 × 2 system, the analysis shows in a relatively...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Doboku Gakkai Ronbunshu
سال: 1995
ISSN: 0289-7806,1882-7187
DOI: 10.2208/jscej.1995.529_103