Reshape Machine Tool Principal Axis System Dynamic Simulation of Electromechanical Coupling
نویسندگان
چکیده
منابع مشابه
Dynamic Electromechanical Coupling of Piezoelectric Bending Actuators
Abstract: Electromechanical coupling defines the ratio of electrical and mechanical energy exchanged during a flexure cycle of a piezoelectric actuator. This paper presents an analysis of the dynamic electromechanical coupling factor (dynamic EMCF) for cantilever based piezoelectric actuators and provides for the first time explicit expressions for calculation of dynamic EMCF based on arrangeme...
متن کاملRemote Servo Tuning System for Multi-Axis CNC Machine Tools Using a Virtual Machine Tool Approach
Servo systems affect the performances of machining in accuracy and surface quality for high speed and precision machine tools. This study introduces an efficient servo tuning technique for Computer Numerical Control (CNC) feed drive systems using particle swarm optimization (PSO) algorithm by virtual machine tool approach. The proposed approach contained a system identification phase and a serv...
متن کاملElectromechanical coupling I. Introduction.
In skeletal muscle fibres contraction is initiated by the action potential which travels inward along the transverse tubular system and causes in some way the release of Ca from the terminal cisternae of the sarcoplasmic reticulum (SR). Ca-release is probably controlled by a potential-sensor (intram em brane charge movement) in the wall of the T-system which in a triad is about 10 20 nm apart f...
متن کاملReal Time Dynamic Simulation of Power System Using Multiple Microcomputers
Recent developments in the design and manufacture of microcomputers together with improved simulation techniques make it possible to achieve the speed and accuracy required for the dynamic simulation of power systems in real time. This paper presents some experimental results and outlines new ideas on hardware architecture, mathematical algorithms and software development for this purpose. The ...
متن کاملEvaluation of servo, geometric and dynamic error sources on five axis high-speed machine tool
Many sources of errors exist in the manufacturing process of complex shapes. Some approximations occur at each step from the design geometry to the machined part. The aim of the paper is to present a method to evaluate the effect of high speed and high dynamic load on volumetric errors at the tool center point. The interpolator output signals and the machine encoder signals are recorded and com...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Procedia
سال: 2011
ISSN: 1876-6102
DOI: 10.1016/j.egypro.2011.12.383