Research on Optimization for the Piston Pin and the Piston Pin Boss
نویسندگان
چکیده
منابع مشابه
Research on the Piston with Damping Hole and Pressure Recess of Axial Piston Motor
Based on the principle of hydrostatic bearing, in this study, several novel kinds of pistons were designed out, and the mathematic model of hydrostatic bearing on piston was established and analyzed. It was also found that, the diameter of damping hole and the width of pressure recess had impact on the radial load capacity of piston, the overall efficiency of axial piston motor, and the frictio...
متن کاملThe Half - Pin and the Pin Tract :
A lthough the key principles of external fixation have changed little over the years, there remains a significant amount of variation in fixation methods and postoperative care. In particular, use and management of halfpins intended for prolonged reconstruction are the subject of strong opinions and intense debate. Half-pins are commonly available in stainless steel and titanium. They are also ...
متن کاملThe stochastic piston problem.
We obtain analytical solutions for the perturbed shock paths induced by time-varying random motions of a piston moving inside an adiabatic tube of constant area. The variance of the shock location grows quadratically with time for early times and switches to linear growth for longer times. The analytical results are confirmed by stochastic numerical simulations, and deviations for large random ...
متن کاملPin-Collinear Body-and-Pin Frameworks and the Molecular Conjecture
T-S. Tay and W. Whiteley independently characterized the multigraphs which can be realized as an infinitesimally rigid d-dimensional body-and-hinge framework. In 1984 they jointly conjectured that each graph in this family can be realized as an infinitesimally rigid framework with the additional property that the hinges incident to each body lie in a common hyperplane. This conjecture has becom...
متن کاملInvestigating the effect of nanocoating on friction loss and abrasion in the piston rings
The piston ring which prepares mechanical sealing of a combustion chamber, should have significant abrasion resistance and less friction loss, using appropriate ring coating. The coating widely used is CrN, because of its good abrasion resistance at room temperature. However, it suffers from some shortcomings, such as high abrasion rate at temperatures above 200°C and lack of self-lubricating p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Open Mechanical Engineering Journal
سال: 2011
ISSN: 1874-155X
DOI: 10.2174/1874155x01105010186