RESEARCH ON HYDRAULIC CYLINDER POSITION CONTROL USING CONSTANT PRESSURE SYSTEM

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Model-based force and position tracking control of a multi- pressure hydraulic cylinder

This paper presents a force control solution for a throttle-free multi-pressure hydraulic cylinder actuator. A model-based force controller was developed and the position and velocity tracking control was implemented using low-order linear controllers. Special attention was paid to robustness against variations in the load mass, bulk modulus and system delay. Experimental results demonstrated e...

متن کامل

The Research on the Position Control of the Hydraulic Cylinder Based on the Compound Algorithm of Fuzzy & Feedforward-feedback

This paper aims to research the position control of the hydraulic cylinder controlled by the high-speed on-off valve to realize the precise position control. The strategy combining the pulse width modulation with pulse frequency modulation is proposed to compensate the dead and saturated zones of the high-speed on-off valve, which is on the groundwork of the analysis of the flow characteristic ...

متن کامل

The Position Control of the Hydraulic Cylinder Controlled by the High-Speed On-Off Valve

This paper aims to research the position control of the hydraulic cylinder controlled by the highspeed on-off valve to realize the precise position control. A compound algorithm of proportional integral & speed feedforwarddisplacement feedback is put forward based on the research on the relationship between the duty ratio and the past flow for the high speed on-off valve. The speed feedforwardd...

متن کامل

Conception of Cylinder Pressure Based Diesel Injection Control System

Control of diesel fuel injection is very important and has influence not only at engine operating conditions but also at emission of toxic gases as NOx, HC, and Particulate Matter (PM) are effect of combustion process. Directly observing of combustion process is very difficult, but implementation to injection control algorithm procedures based on additional sensors as knock sensor, cylinder pre...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Proceedings of the JFPS International Symposium on Fluid Power

سال: 2002

ISSN: 2185-6303

DOI: 10.5739/isfp.2002.579