Research on Hot-Wire Low Pressure Wind Speed Measurement System
نویسندگان
چکیده
منابع مشابه
A Wire-Driven Parallel Suspension System with 8 Wires (WDPSS-8) for Low-Speed Wind Tunnels
As a new type of parallel manipulator, the wire-driven parallel manipulator has advantageous characteristics such as simple and reconfiguration structure, large workspace, high load capacity, high load/weight ratio, easy assembly/disassembly, high modularization, low cost and high speed. A new concept has been proposed by using the wire-driven parallel manipulator as aircraft model suspension s...
متن کاملAlgorithm to optimize transient hot-wire thermal property measurement.
The transient hot-wire method has been widely used to measure the thermal conductivity of fluids. The ideal working equation is based on the solution of the transient heat conduction equation for an infinite linear heat source assuming no natural convection or thermal end effects. In practice, the assumptions inherent in the model are only valid for a portion of the measurement time. In this st...
متن کاملSupply Voltage Compensation of Hot Wire Flow Measurement Device
Supply voltage compensation is important to keep the accuracy for hot wire/hot film gas flow sensors. A compensation experiment device is established, the two steps curve fitting is presented to determine the functional relations among flow、sensor output and supply voltage, the coefficient of fitting polynomial is determined by Least Square method, thus eliminating the influence of supply volta...
متن کاملField Measurement for Aerodynamic Mitigation of Wind Pressure on Gable-roofed Low-rise Building
The components and claddings of low-rise building are usually destroyed first during typhoon disasters in coastal areas. Roof accessory structures can change the flow pattern on the roof, thus effectively reducing the wind load on the roof surface and the damage to the low rise buildings. Two types of aerodynamic mitigation plates, i.e., (1) 0.3 m high full length roof-edge plate, and (2) 0.3 m...
متن کاملLow-Speed Wind-Tunnel Tests on some Slender Airbus Configurations
An experimentalinvestigation has been made of the subsonic lift, drag and longitudinal stability characteristics of models representing some alternative slender airbus configurations. For the same wing planform of aspect ratio 1.4 the lift, drag and pitching moment have been measured for two wings of maximum thickness/chord ratio 4 and 9 per cent respectively, both without and with various body...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATEC Web of Conferences
سال: 2018
ISSN: 2261-236X
DOI: 10.1051/matecconf/201817901025