Research on Friction Stir Spot Welding Brazing Process and Properties of Dissimilar Metals DP590 and 6061
نویسندگان
چکیده
منابع مشابه
Microstructure and Mechanical Properties of Dissimilar Friction Stir Welding between Ultrafine Grained 1050 and 6061-T6 Aluminum Alloys
The ultrafine grained (UFGed) 1050 Al plates with a thickness of 2 mm, which were produced by the accumulative roll bonding technique after five cycles, were friction stir butt welded to 2 mm thick 6061-T6 Al alloy plates at a different revolutionary pitch that varied from 0.5 to 1.25 mm/rev. In the stir zone, the initial nano-sized lamellar structure of the UFGed 1050 Al alloy plate transforme...
متن کاملForming and Properties of Friction Stir Welding Process for Dissimilar Mg Alloy
For hot extrusions of magnesium alloy sheets, Dissimilar AZ80 and AZ31 were used, in which AZ80 was placed on advancing side and AZ31 on retreating side, using friction stir butt welding with different process parameters. Some defect-free welded joints with good weld surfaces could be obtained with some suitable welding conditions. The maximum tensile strength of welded joint which is 225.5 MPa...
متن کاملEvaluation of microstructure and mechanical properties of friction stir welded copper / 316L stainless steel dissimilar metals
In the present research, friction stir welding (FSW) process was used for butt joining of pure copper plate to 316L stainless steel plate. Mechanical properties and microstructural characteristics of the joint were evaluated by microhardness and tensile tests as well as optical and scanning electron microscope (SEM). It was found that microstructure of the weld nugget (WN) has fine grains where...
متن کاملFriction Welding to Join Dissimilar Metals
The purpose of this work was to join and assess the development of solid state joints of dissimilar material AA6082 aluminum alloy and AISI 304 stainless steel, via continuous drive friction welding process, which combines the heat generated from friction between two surfaces and plastic deformation. Tests were conducted with different welding process parameters. The results were analyzed by me...
متن کاملFriction stir welding of dissimilar alloys – a perspective
Friction stir welding does not involve bulk melting of the components that are joined. This has inspired attempts to exploit it for joining materials which differ in properties, chemical composition or structure, and where fusion can lead to detrimental reactions. The purpose of this special issue of Science and Technology of Welding and Joining was to assess the status of friction stir welding...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Materials Science and Engineering
سال: 2020
ISSN: 1687-8434,1687-8442
DOI: 10.1155/2020/9701976