Research on Fault Location Method of GIS Busbar Based on Fault Current Distribution
نویسندگان
چکیده
منابع مشابه
Research on Fault Location Method Based on Nonlinear Impedance Model
In modeling and location analysis, most traditional fault location methods do not consider about the existence of practical nonlinear model in distribution network, such as the nonlinearity of load and grounding resistor. Hence, the adopted model can’t express the practical network, and the location results will lose practical meaning. Aiming at solving the question above, this paper proposes a...
متن کاملfault location in power distribution networks using matching algorithm
چکیده رساله/پایان نامه : تاکنون روشهای متعددی در ارتباط با مکان یابی خطا در شبکه انتقال ارائه شده است. استفاده مستقیم از این روشها در شبکه توزیع به دلایلی همچون وجود انشعابهای متعدد، غیر یکنواختی فیدرها (خطوط کابلی، خطوط هوایی، سطح مقطع متفاوت انشعاب ها و تنه اصلی فیدر)، نامتعادلی (عدم جابجا شدگی خطوط، بارهای تکفاز و سه فاز)، ثابت نبودن بار و اندازه گیری مقادیر ولتاژ و جریان فقط در ابتدای...
Fault Location on Compensated Transmission Lines without Current Measurement
This paper presents a novel fault location method for series compensated transmission lines. It is established based on synchronized voltages sampling and Thevenin impedance from both ends of series compensated transmission line. The method is based on the use of phasor measurement units (PMU) technology which is aimed to be independent of current measurements, fault type, fault resistance, fau...
متن کاملFault Location in Distribution Systems Based on Artificial Neural Networks and Application of Gis
This paper presents a novel approach for fault location in distribution system using neural network. The voltage and current in the instance of fault are used for training. Different faults are simulated in a specific feeder by PSCAD software. The MATLAB and EMTDC are used for simulation in this work. The results of case studies show the capability of neural networks in fault location with negl...
متن کاملThe Impact of Superconducting Fault Current Limiter Locations on Voltage Sag in Power Distribution System
In this paper, the impacts of installing superconducting fault current limiter (SFCL)in radial and loop power distribution system are evaluated to improve voltage sag in both cases of with and without distributed generations (DG). Among various SFCLs, the hybrid type with a superconducting element in parallel with a current limiting reactor (CLR) is selected. This is more effective than resisto...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Electrical Engineering
سال: 2016
ISSN: 2333-5394,2333-5424
DOI: 10.12677/jee.2016.41002