Research of Reinforced Composite Samples Strength at Three-Point Bending
نویسندگان
چکیده
منابع مشابه
Shear Strength of Lightly Reinforced T-Beams in Negative Bending
Nine restrained T-beams were tested in a study of the negative moment region shear strength of lightly reinforced concrete T-beams. Variables included the longitudinal reinforcement ratio p, (0.47 percent and 0. 70 percent) and the nominal stirrup strength (0 to 84 psi [0 to 0.60 MPa]). The test results are compared with the shear provisions of "Building Code Requirements for Reinforced Concret...
متن کاملExploration of the Customized Fixtures for the Evaluation of Three-point Bending Strength of Dental Resin Composites
Introduction: This study aimed to devise customized fixtures for the evaluation of three-point bending strength (TPBS) of resin-based dental composites (RBCs). Materials and Methods: A cube-shaped jig made out of wood with dimensions of 105×105×101 mm was prepared in this study. A 20-mm-diameter hole was made in the center of the wooden jig. In addition, a stai...
متن کاملCluster Analysis of Acoustic Emission Signals for Carbon/Epoxy Composite in Four-point Bending Test (RESEARCH NOTE)
Due to the extensive use of composites in various industries and the fact that defects reduce ultimate strength and efficiency during operation, detection of failures in composite parts is very important. The aim of this paper is to use Acoustic Emission (AE) non-destructive method in four-point bending test of carbon/epoxy composite to analyze and examine the failure mechanisms. This method is...
متن کاملA Clamped Three-point Bending Setup for Fatigue of Thin Composite Laminates
Usually, fatigue tests on fibre-reinforced composites are performed in uni-axial tension/tension or tension/compression fatigue [1], providing the S-N data. Although bending fatigue tests are not widely accepted as a standard, they are used a lot for research purposes [2] and they do have some important advantages [3]. In case of three-point bending fatigue, the history of bending force versus ...
متن کاملincrease of composite bending strength through fiber tensioning -technical note
in the present research work, the flexural modulus and strength of glass fiber-epoxy resin and carbon fiber-epoxy resin composites have been enhanced through fiber tension during curing of the polymeric resin. this study showed that the tension applied on the fibers increased the flexural modulus of the glass-epoxy composites up to 12% and the flexural strength up to 19%. the flexural modulus a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Education of the Bauman MSTU
سال: 2014
ISSN: 1994-0408
DOI: 10.7463/1214.0750942