RESEARCH COMMON MODE REJECTION IN CONDUCTOMETRIC BIOSENSOR SYSTEM WITH DIFFERENTIAL SENSORS

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An area-efficient differential input ADC with digital common mode rejection

This paper presents a di erential input ash ADC with digital common mode rejection (DCMR) and dithered, noise shaped requantization used in a high-performance, single-poly CMOS ADC modulator IC. By avoiding the use of metal-metal capacitors, the DCMR ash ADC required 14% less area than a switched-capacitor implementation and avoided circuit implementation problems. Measurements and analysis sho...

متن کامل

A Digital Common-Mode Rejection Technique for Differential Analog-to-Digital Conversion

A multibit analog-to-digital converter can achieve high resolution with a lower order modulator and lower oversampling ratio than a single-bit design, but it requires a multibit internal flash analog-to-digital converter rather than a simple comparator. In an implementation with a fully differential analog front end, the flash analog-to-digital converter must quantize a differential voltage rel...

متن کامل

A Conductometric Indium Oxide Semiconducting Nanoparticle Enzymatic Biosensor Array

We report a conductometric nanoparticle biosensor array to address the significant variation of electrical property in nanomaterial biosensors due to the random network nature of nanoparticle thin-film. Indium oxide and silica nanoparticles (SNP) are assembled selectively on the multi-site channel area of the resistors using layer-by-layer self-assembly. To demonstrate enzymatic biosensing capa...

متن کامل

A Fully Balanced Pseudo-Differential OTA With Common-Mode Feedforward and Inherent Common-Mode Feedback Detector

A pseudo-differential fully balanced fully symmetric CMOS operational transconductance amplifier (OTA) architecture with inherent common-mode detection is proposed. Through judicious arrangement, the common-mode feedback circuit can be economically implemented. The OTA achieves a third harmonic distortion of 43 dB for 900 mVpp at 30 MHz. The OTA, fabricated in 0.5m CMOS process, is used to desi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Sensor Electronics and Microsystem Technologies

سال: 2014

ISSN: 2415-3508,1815-7459

DOI: 10.18524/1815-7459.2014.3.108258