REPEATED IMPACT TESTS ON PLAIN CARBON AND Si-Mn SPRING STEELS
نویسندگان
چکیده
منابع مشابه
ULTRA FINE FERRITE FORMATION IN Si-Mn TRIP STEELS
Abstract: In the present investigation, the effects of thermomechanical processing parameters and the steel chemical composition on the ultra fine ferrite formation characteristics were studied. This was programmed relying on the capabilities of strain induced transformation (SIT) phenomenon and applying to different grades of Si-Mn TRIP (Transformation Induced Plasticity) steels. According...
متن کاملTHE EFFECT OF STRAINING BEFORE AND DURING AUSTENITE TO FERRITE TRANSFORMATION ON THE FINAL CHARACTERISTICS OF SI-MN TRIP STEELS
TRIP (TRansformation- lnduced- Plasticity) behavior is a powerful mechanism to improve mechanical properties. The basis of TRIP phenomena is the transformation of retained austenite with optimum characteristics (volume fraction, stability, size and morphology) to martensite during deformation at room temperature. Accordingly, the first requirement to obtain desired TRIP effects is to produce an...
متن کاملPREDICTION OF CRITICAL STRESS AND STRAIN FOR THE ONSET OF DYNAMIC RECRYSTALLIZATION IN PLAIN CARBON STEELS
The aim of the present study is the prediction of critical conditions (including critical strain and flow stress) for the initiation of dynamic recrystallization during thermo-mechanical processing of plain carbon steels. For this propose, torsion tests were conducted at different temperature (1050, 1100 and 1150˚C) and strain rates (0.002, 0.02 and 0.2/s). All flow curves showed a peak st...
متن کاملSTRAIN INDUCED AUSTENITE-TO-FERRITE TRANSFORMATION BEHAVIOR OF PLAIN CARBON STEELS THROUGH SINGLE PASS ROLLING
In principal, a proper combination of strength and ductility is achieved through micro component refinement in steels. This is particularly empowered with ferrite refinement down to micron sizes in ferrite pearlite engineering steels. The latter is achieved through various well-defined methods in which strain induced transformation (SIT) has shown spectacular capabilities. In the present study,...
متن کاملVariation of Transition Temperatures from Upper to Lower Bainites in Plain Carbon Steels
Experimental results and explanations for the transition temperature from upper to lower bainites in carbon steels containing from 0.20 to 1.80 wt%C were presented metallographically and kinematically. The experimental results are summarized as follows: I) Lower bainite is not formed in steels with less than 0.35 wt%C and no transition from upper to lower bainite occurs. 2) The transition tempe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1949
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1915.35.11_397