REPAIR AND STRENGTHEINING OF STEEL COMPRESSION MEMBERS USING CFRP MEMBERS FABRICATED BY VARTM TECHNIQUE

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Fatigue and Overloading Behavior of Steel-Concrete Composite Flexural Members Strengthened with High Modulus CFRP Materials

Due to corrosion and the continuous demand to increase traffic loads, there is a need for an effective system which can be used to repair and/or strengthen steel bridges and structures. This paper describes an experimental program, recently completed, to investigate the fundamental behavior of steel-concrete composite scaled bridge beams strengthened with new high modulus carbon fiber reinforce...

متن کامل

Strengthening of Corroded Reinforced SCC-RAP Members with CFRP

Corrosion is one of the major problems affecting the durability of reinforced concrete (RC) structures. This paper investigates the effect of rebar corrosion on the performance of reinforced self-consolidating concrete (SCC) members and the effectiveness of repair. A control RC member, which has no corrosion problem, was prepared to compare against corroded and repaired members. A number of rei...

متن کامل

Monitoring Fracture of Steel Corroded Reinforced Concrete Members under Flexure by Acoustic Emission Technique

Acoustic emission (AE) technique is used for monitoring and evaluating the influence of corrosion on the structural behaviour of steel reinforced concrete (RC) beams under three-point flexure test. In this study, steel corrosion was accelerated by electro-chemical method utilising a direct current (DC) power supply and 5% sodium chloride (NaCl) solution. The steel corrosion that was induced int...

متن کامل

Local and Distortional Buckling of Cold-Formed Steel Members

Laminar structures have a high post-buckling strength reserve. Cold-formed steel profiles can be taken as a set of thin plate elements. Therefore it is necessary to design this type of profiles taking into account that reserve of strength in post-local buckling modes of failure. The method normally used to design this type of structures is based on the Effective Width concept. The Effective Wid...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Japan Society of Civil Engineers, Ser. A1 (Structural Engineering & Earthquake Engineering (SE/EE))

سال: 2018

ISSN: 2185-4653

DOI: 10.2208/jscejseee.74.ii_67