Relative timing jitter measurements with an indirect phase comparison method
نویسندگان
چکیده
منابع مشابه
Equalization-enhanced phase noise induced timing jitter.
In electronic digital signal processing based optical communication systems, digital equalization for chromatic dispersion interacts with local oscillator phase noise to produce equalization-enhanced phase noise (EEPN). In addition to both phase and intensity noises, EEPN also induces timing jitter to the equalized signal. For a 100 Gbit/s quadrature-phase-shift keying signal with laser linewid...
متن کاملClock Division with Jitter and Phase Noise Measurements White Paper
As clock speeds and communication channels run at ever higher frequencies, accurate jitter and phase noise measurements become more important, even as they become more difficult and expensive to manage. While measuring ultra low-jitter devices and equipment, the engineer is continually required to ask whether the measurement values are the result of the device under test (DUT) or if they are du...
متن کاملTiming Jitter Measurements at the Slc Electron Source’
The SLC thermionic gun and electron source produce a beam of up to 15 x 10” ein a single S-band bunch. A 170 keV, 2 ns FWHM pulse out of the gun is compressed by means of two subharmonic buncher cavities followed by an S-band buncher and a standard SLAC accelerating section. Ceramic gaps in the beam pipe at the output of the gun allow a measure of the beam intensity and timing. A measurement at...
متن کاملTiming and phase jitter suppression in coherent soliton transmission.
We have revisited soliton transmission in the new context of coherent optical detection optimizing and comparing digital backward propagation and in-line optical filtering as a means to suppress soliton timing and phase jitter. We find that in-line optical filtering allows one to improve the reach of the soliton system by up to the factor of 2. Our results show that nonlinear propagation can le...
متن کاملJitter Measurements
The TTCrx mezzanine card was installed on the Clock and Control Board [2] and connected to a TTCvx module via a 100 m optical cable. The TTCvx provided the 40.00 Mhz clock source for the TTCvi module. Measurements were conducted while repeatedly transmitting two broadcast (BC) commands over channel B and L1 Accept over channel A (case 1) and then again without the BC commands / L1 Accepts (case...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Physics B
سال: 2005
ISSN: 0946-2171,1432-0649
DOI: 10.1007/s00340-004-1704-2