منابع مشابه
The Failure Mechanism of Recrystallization – Assisted Cracking of Solder Interconnections
The typical user environment load spectrum varies significantly between different electronic applications but changes in temperature are involved in nearly all of them. Owing to the increasing number of integrated high-performance functions, smartphones and handheld computers, for example, can experience significant changes in temperature during normal operation. The changes in temperature are ...
متن کاملSimulation and Optimization of a Naphtha Thermal Cracking Pilot Plant
In thermal cracking plants, it is desired to apply an optimal temperature profile along the reactor to minimize the operation cost. In this article a simulator is developed by the use of a mathematical model, which describes the static operation of a naphtha thermal cracking pilot plant. The model is used to predict the steady state profiles of the gas temperature and product yields. Using ...
متن کاملReheat furnace scheduling with energy consideration
This paper focuses on the reheat furnace scheduling problem (RFSP) which is to assign the slabs to the reheat furnace, make the slab sequence for each furnace and determine the feed-in time and the residence time for each slab in order to reduce the unnecessary energy consumption reflected by minimising the objective under consideration. Differing from the traditional scheduling problem, the ac...
متن کاملConstruction and testing of a hydrogen cracking cell
A UHV atomic hydrogen-cracking cell has been constructed to produce atomic hydrogen in order to perform in-situ cleaning of semiconductor samples. The cell was calibrated and tested with the objective of cleaning the III-V semiconductor samples such as GaAs. Mass spectroscopy studies during the atomic hydrogen cleaning of the GaAs samples revealed the chemical process of the hydrogen cleaning. ...
متن کاملDynamic Response Analysis of Automatic Generation Control in a 2 - Area ( Reheat & Non - Reheat ) Interconnected Power System and a Scheme for Improvement of Response for the Same
Abstract: In the present work, we focus on the study of dynamic behavior of an interconnected two-area power system and a scheme for improvement of response for the same. Here, two-area system with one non-reheat thermal units & one reheat thermal units is considered. The frequency and tie-line power deviation of two units are studied using MATLAB-SIMULINK in continuous time domain and also in ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1992
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.61.6_469