Reduction of temperature-power stress in cutting process using leading plastic forming
نویسندگان
چکیده
منابع مشابه
Stress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملfault location in power distribution networks using matching algorithm
چکیده رساله/پایان نامه : تاکنون روشهای متعددی در ارتباط با مکان یابی خطا در شبکه انتقال ارائه شده است. استفاده مستقیم از این روشها در شبکه توزیع به دلایلی همچون وجود انشعابهای متعدد، غیر یکنواختی فیدرها (خطوط کابلی، خطوط هوایی، سطح مقطع متفاوت انشعاب ها و تنه اصلی فیدر)، نامتعادلی (عدم جابجا شدگی خطوط، بارهای تکفاز و سه فاز)، ثابت نبودن بار و اندازه گیری مقادیر ولتاژ و جریان فقط در ابتدای...
FE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملFE-Based Analysis of Hot Forming Process Using the Flow Stress Prediction Model
In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science intensive technologies in mechanical engineering
سال: 2016
ISSN: 2223-4608
DOI: 10.12737/18081