Recycling of WEEE Plastics Waste in Mortar: The Effects on Mechanical Properties

نویسندگان

چکیده

This work focused on the recycling of WEEE plastic waste as a partial substitute for aggregate in light mortars. The mix, provided by IREN group, was used replacement 15, 30, 45, 60, 75, and 90%vol Worsening mechanical performance around 50% detected already at only 15%vol mineral substituted with waste. explanation this phenomenon found both scarce properties poor adhesion between matrix plastics that resulted extra-porosity formation, also demonstrated comparing results several models literature. However, use natural contributes to preservation resources and, any case, does not limit application these materials non-structural applications.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

the effects of changing roughness on the flow structure in the bends

flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...

Effects of Pozzolanic Admixture (Waste Bricks) on Mechanical Response of Mortar

This work presents an experimental study realized at the materials laboratory of the University of M’sila. It consists to vary the percentage of the pozzolanic admixture (waste bricks) in cement by the substitution method (partial replacement of the clinker by the calcined clay). The characteristics of cement at anhydrous state and the hydrated state (chemical composition, specific weight and f...

متن کامل

Mechanical Properties of Polymer Mortar Containing Pet Waste Aggregates

Non-biodegradable plastic aggregates made of polyethylene terephthalate (PET) waste from beverage containers are used as partial replacement of natural aggregates in mortar. Various weight fractions of sand 5%, 10%, 15% and 20% are replaced by the same weight of plastic. This paper investigates the mechanical properties of the obtained composites. The main results of this study show the feasibi...

متن کامل

The Influence of Compatibilizer Addition and Gamma Irradiation on Mechanical and Rheological Properties of a Recycled WEEE Plastics Blend

Waste electrical and electronic equipment (WEEE) is growing rapidly, and the plastics within WEEE have an important role in fulfilling the recovery and recycling targets defined in the European WEEE Directive. This study considers recycling of WEEE plastics by making a blend of the different plastics instead of separating them. The mechanical and thermal properties can be enhanced by adding a c...

متن کامل

modification of nanoclay for improving the physico-mechanical properties of dental adhesives

هدف اصلی این مطالعه تهیه یک سامانه نوین چسب عاجی دندانی بر پایه نانورس پیوند شده با پلی متاکریلیک اسید، نانورس پیوند شده با پلی اکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی متاکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی اکریلیک اسید و نانورس پیوند شده با کیتوسان اصلاح شده با گلایسیدیل متاکریلات است. پیوند پلی متاکریلیک اسید و پلی اکریلیک اسید بر ری سطح نانورس در حضور و ...

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Recycling

سال: 2021

ISSN: ['2313-4321']

DOI: https://doi.org/10.3390/recycling6040070