Recrystallization and Hot Tensile Behaviour of Single Phase Stainless Steels
نویسندگان
چکیده
منابع مشابه
Dynamic Recrystallization and Hot Workability of 316LN Stainless Steel
Chaoyang Sun 1,*, Yu Xiang 1, Qingjun Zhou 2, Denis J. Politis 3, Zhihui Sun 1,* and Mengqi Wang 1 1 School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China; [email protected] (Y.X.); [email protected] (M.W.) 2 Capital Aerospace Machinery Company, Beijing 100076, China; [email protected] 3 Department of Mechanical Engineering, Imperial Co...
متن کاملTensile Tests on Stainless Steels in Temperature Range
In real conditions, austenitic stainless steels solidify in non equilibrium and a two phases microstructure of austenite and ferrite is formed 1 . The aim of this work was to investigate the behaviour of both phases at tensile testing, especially to find out an eventual difference in the relaxation of the deformation energy and the effect of the two phases microstructure in workability. To achi...
متن کاملDynamic Recrystallization under Hot Deformation of a PH Stainless Steel
Dynamic recrystallization, DRX, behaviour of a precipitation hardened, PH, stainless steel was studied in connection with microstructural developments in a compression test. The experimental results showed that the dominant mechanism of softening is DRX, but at high strain rates and low temperatures, ie, high Zener-Holman parameter, Z, work hardening and dynamic recovery, DRV, produced a pancke...
متن کاملHot tensile properties and strain hardening behaviour of Super 304HCu stainless steel
Super 304HCu austenitic stainless steel containing 2.3–3 (wt.%) of Cu is mainly used in superheaters and reheaters tubing of ultra super critical boilers which operates over 600 ◦C of steam temperature. Tensile tests were carried out on Super 304HCu, using nominal strain rate of 1 × 10−3 s−1, at room temperature, 550 ◦C, 600 ◦C and 650 ◦C. The tensile strength and elongation were found to decre...
متن کاملStudy on Oxidation of Stainless Steels During Hot Rolling
The oxidation of stainless steels 304 and 304L during hot rolling is studied in this paper. Results show the oxide scale thickness decreases significantly with an increase of reduction, and the oxide scales of both 304 and 304L stainless steels were found more deformable than the steel substrate. Surface roughness shows a complicated transfer during the hot rolling process due to the complexity...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1989
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.75.7_1193