Recovery Stress of TiNi Shape Memory Alloy. 2nd Report. Properties under Constant Maximum Strain.
نویسندگان
چکیده
منابع مشابه
Deformation Properties of TiNi Shape Memory Alloy
In order to describe the deformation properties due to the martensitic transformation and the R-phase transformation of TiNi shape memory alloy, a thermomechanical constitutive equation considering the volume fractions of induced phases associated with both transformations is developed. The proposed constitutive equation expresses well the properties of the shape memory effect, pseudoelasticity...
متن کاملThermomechanical Properties of TiNi Shape Memory Alloy
The thermomechanical properties of shape memory effect and superelasticity due to the martensitic transformation and the R-phase transformation of TiNi shape memory alloy were investigated experimentally. The transformation line, recovery stress and fatigue property due to both transformations were discussed for cyclic deformation. The thermomechanical properties due to the R-phase transformati...
متن کاملTransformation-Induced Relaxation and Stress Recovery of TiNi Shape Memory Alloy
The transformation-induced stress relaxation and stress recovery of TiNi shape memory alloy (SMA) in stress-controlled subloop loading were investigated based on the local variation in temperature and transformation band on the surface of the tape in the tension test. The results obtained are summarized as follows. (1) In the loading process, temperature increases due to the exothermic martensi...
متن کاملResidual Stress of TiNi Shape Memory Alloy Thin Films with (111) Single-crystal Silicon Wafer
As micro-actuator materials, TiNi shape memory alloy thin films with substrate are used more and more in MEMS field. The residual stress in Ti-rich TiNi thin films with silicon substrate prepared by the magnetron-sputtering technique is measured by both X-ray glancing and contour method. The influence of crystallization annealing temperature and film thickness on the residual stress is tested. ...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1994
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.60.120