Reconfiguration for the Maximum Dynamic Wrench Capability of a Parallel Robot
نویسندگان
چکیده
منابع مشابه
Reconfiguration for the Maximum Dynamic Wrench Capability of a Parallel Robot
Chih-Jer Lin 1 and Chun-Ta Chen 2,* 1 Graduate Institute of Automation Technology, National Taipei University of Technology, 1, Section 3, Chung-Hsiao E. Road, Taipei 10608, Taiwan; [email protected] 2 Department of Mechatronic Engineering, National Taiwan Normal University, 162, Section 1, He-ping East Road, Taipei 10610, Taiwan * Correspondence: [email protected]; Tel.: +886-2-7734-3528; Fax...
متن کاملFailure recovery for wrench capability of wire-actuated parallel manipulators
—In this paper, the failure of wireactuated parallel manipulators is examined considering their failure modes. A methodology for investigating the effect of actuator/wire failures on the force/moment capability of manipulators is presented, and the criteria for full and partial recovery from these failures are established. The methodology is also applicable for the cases that the minimum norm ...
متن کاملModeling and Wrench Feasible Workspace Analysis of a Cable Suspended Robot for Heavy Loads Handling
Modeling and Wrench feasible workspace analysis of a spatial cable suspended robots is presented. A six-cable spatial cable robot is used the same as Stewart robots. Due to slow motion of the robot we suppose the motion as pseudostatic and kinetostatic modeling is performed. Various workspaces are defined and the results of simulation are presented on the basis of various workspaces and app...
متن کاملa new type-ii fuzzy logic based controller for non-linear dynamical systems with application to 3-psp parallel robot
abstract type-ii fuzzy logic has shown its superiority over traditional fuzzy logic when dealing with uncertainty. type-ii fuzzy logic controllers are however newer and more promising approaches that have been recently applied to various fields due to their significant contribution especially when the noise (as an important instance of uncertainty) emerges. during the design of type- i fuz...
15 صفحه اولTowards a generic operational amplifier with dynamic reconfiguration capability
Analog and analog-digital mixed signal electronics needed for sensor systems are indispensable components which tend to drifts from the normal phase of operation due to the impact of manufacturing conditions and environmental influences like etching, aging etc. Precise design methodology, trimming / calibration are essential to restore functionality of the system. Recent block level granular ap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2016
ISSN: 2076-3417
DOI: 10.3390/app6030080