Recent Research on Spark Sintering Process.

A strategy to optimize the thermoelectric performance in a spark plasma sintering process

Spark plasma sintering (SPS) is currently widely applied to existing alloys as a means of further enhancing the alloys' figure of merit. However, the determination of the optimal sintering condition is challenging in the SPS process. This report demonstrates a systematic way to independently optimize the Seebeck coefficient S and the ratio of electrical to thermal conductivity (σ/κ) and thus ac...

Mechanical Study of Copper Bonded at Low Temperature Using Spark Plasma Sintering Process

Bonding of high purity polished copper was investigated using the Spark Plasma Sintering technique (SPS) showing the effect of SPS parameters (surface roughness, time, temperature and pressure) on the bonding strength behaviour. Mechanical characterization of the bonded samples was performed at room temperature using tensile test. Two surfaces roughnesses were studied (un-polished and polished ...

Spark Plasma Sintering of Negative Temperature Coefficient Thermistor Ceramics

Studies on sintering process of synthetic hydroxyapatite.

In this study the effect of sintering process in different temperatures on microstructure and morphological properties of sintered hydroxyapatite (HAp) was investigated. HAp powder was prepared by wet precipitation method from following reagents: Ca(OH)2 + H3PO4 in an alkaline conditions. Thermal analysis (TA), X-Ray diffraction method (XRD), FT-IR spectrometry (FT-IR) and scanning electron mic...

Full densification of Molybdenum powders using Spark Plasma Sintering

Pure molybdenum powder was sintered using Spark Plasma Sintering under various temperatures, and holding times, under a pressure of 77 MPa and a heating rate at 700°C/min. After sintering, a carbide layer was observed at the surface. The carbide layer thickness, the relative density of the sample as well as the microhardness and the grain size of Mo were measured. The carbide thickness depends ...