Recent progress in direct patterning technologies based on nano-imprint lithography
نویسندگان
چکیده
منابع مشابه
3D Simulation of Nano-Imprint Lithography
A proof of concept study of the feasibility of fully three-dimensional (3D) time-dependent simulation of nano-imprint lithography of polymer melt, where the polymer is treated as a structured liquid, has been presented. Considering the flow physics of the polymer as a structured liquid, we have followed the line initiated by de Gennes, using a Molecular Stress Function model of the Doi and Edwa...
متن کاملNegative index fishnet with nanopillars formed by direct nano-imprint lithography
In this paper we demonstrate the ability to fabricate fishnets by nanoimprinting directly into a pre-deposited three layer metal–dielectric–metal stack, enabling us to pattern large areas in two minutes. We have designed and fabricated two different fishnet structures of varying dimensions using this method and measured their resonant wavelengths in the near-infrared at 1.45 μm and 1.88 μm. An ...
متن کاملHigh-quality AlN epitaxy on nano-patterned sapphire substrates prepared by nano-imprint lithography
We report epitaxial growth of AlN films with atomically flat surface on nano-patterned sapphire substrates (NPSS) prepared by nano-imprint lithography. The crystalline quality can be greatly improved by using the optimized 1-μm-period NPSS. The X-ray diffraction ω-scan full width at half maximum values for (0002) and (102) reflections are 171 and 205 arcsec, respectively. The optimized NPSS con...
متن کاملNanometer-Scale Patterning on PMMA Resist by Force Microscopy Lithography
Nanoscale science and technology has today mainly focused on the fabrication of nano devices. In this paper, we study the use of lithography process to build the desired nanostructures directly. Nanolithography on polymethylmethacrylate (PMMA) surface is carried out by using Atomic Force Microscope (AFM) equipped with silicon tip, in contact mode. The analysis of the results shows that the ...
متن کاملRecent Advances in Step and Flash Imprint Lithography
The goal of the Step and Flash Imprint Lithography (SFIL) development program is to enable patterning of sub-100 nm features in a manner that has dramatic cost savings over conventional projection lithography techniques. The SFIL process is performed at room temperature and with minimal applied pressure, and we believe the use of low viscosity materials and photopolymerization chemistry will en...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The European Physical Journal Applied Physics
سال: 2012
ISSN: 1286-0042,1286-0050
DOI: 10.1051/epjap/2012120166